Nissan Frontier D22. Instruction — part 88

DTC P1705 THROTTLE POSITION SENSOR

AT-321

[RE4R01A]

D

E

F

G

H

I

J

K

L

M

A

B

AT

DTC P1705 THROTTLE POSITION SENSOR

PFP:22620

Description

ECS007NJ

●

Throttle position sensor
The throttle position sensor detects the throttle valve position
and sends a signal to the TCM.

●

Throttle position switch
Consists of a wide open throttle position switch and a closed
throttle position switch. The wide open position switch sends a
signal to the TCM when the throttle valve is open at least 1/2 of
the full throttle position. The closed throttle position switch sends
a signal to the TCM when the throttle valve is fully closed.

CONSULT-II REFERENCE VALUE IN DATA MONITOR MODE

Remarks: Specification data are reference values.

TCM TERMINALS AND REFERENCE VALUE

Remarks: Specification data are reference values.

ON BOARD DIAGNOSIS LOGIC

AAT495A

Monitor item

Condition

Specification

Throttle position sensor

Fully-closed throttle

Approximately 0.5V

Fully-open throttle

Approximately 4V

Terminal

No.

Wire color

Item

Condition

Judgement stan-

dard (Approx.)

16

BR/W

Closed throttle
position switch
(in throttle posi-
tion switch)

When releasing accelerator pedal
after warming up engine. [Refer to

AT-198, "TCM SELF-DIAGNOSTIC
PROCEDURE (NO TOOLS)"

]

Battery voltage

When depressing accelerator pedal
after warming up engine.

0V

17

OR/B

Wide open throt-
tle position
switch (in throttle
position switch)

When depressing accelerator pedal
more than half-way after warming up
engine. [Refer to

AT-198, "TCM

SELF-DIAGNOSTIC PROCEDURE
(NO TOOLS)"

]

Battery voltage

When releasing accelerator pedal
after warming up engine.

0V

32

B/W

Throttle position
sensor (Power
source)

or

Ignition switch ON

4.5 - 5.5V

Ignition switch OFF

0V

41

OR/L

Throttle position
sensor

When depressing accelerator pedal
slowly after warming up engine.
(Voltage rises gradually in response
to throttle position.)

Fully-closed
throttle: 0.5V
Fully-open throt-
tle: 4V

42

BR

Throttle position
sensor (Ground)

—

0V

AT-322

[RE4R01A]

DTC P1705 THROTTLE POSITION SENSOR

Diagnostic trouble code

Malfunction is detected when ...

Check item

(Possible cause)

: TP SEN/CIRC A/T

TCM receives an excessively low or high
voltage from the sensor.

●

Harness or connectors
(The solenoid circuit is open or shorted.)

●

Throttle position sensor

●

Throttle position switch

: P1705

DTC P1705 THROTTLE POSITION SENSOR

AT-323

[RE4R01A]

D

E

F

G

H

I

J

K

L

M

A

B

AT

DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE

CAUTION:

Always drive vehicle at a safe speed.

NOTE:
If “DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCE-
DURE” has been previously conducted, always turn ignition
switch OFF and wait at least 5 seconds before conducting the
next test.
After the repair, perform the following procedure to confirm the mal-
function is eliminated.

With CONSULT-II

1.

Turn ignition switch ON and select “DATA MONITOR” mode for
“A/T” with CONSULT-II.

2.

Apply vacuum to the throttle opener, then check the following.
Refer to step 1 and step 2 of

AT-198, "TCM SELF-DIAGNOSTIC

PROCEDURE (NO TOOLS)"

.

If the check result is NG, go to

AT-325, "Diagnostic Procedure"

.

If the check result is OK, go to following step.

3.

Turn ignition switch ON and select “DATA MONITOR” mode for
“ENGINE” with CONSULT-II.

4.

Start engine and maintain the following conditions for at least 3
consecutive seconds. Then release accelerator pedal com-
pletely.
VHCL SPEED SE: 10 km/h (6 MPH) or more
THRTL POS SEN: Approximately 3V or less
Selector lever: D position (O/D ON)
If the check result is NG, go to

AT-325, "Diagnostic Procedure"

.

If the check result is OK, go to following step.

5.

Maintain the following conditions for at least 3 consecutive sec-
onds. Then release accelerator pedal completely.
VHCL SPEED SE: 10 km/h (6 MPH) or more
Accelerator pedal: Wide open throttle
Selector lever: D position (O/D ON)

With GST

●

Follow the procedure “With CONSULT-II”.

Accelerator pedal

condition

THRTL POS SEN

CLOSED THL/SW

W/O THRL/P·SW

Fully released

Less than 4.7V

ON

OFF

Partially

depressed

0.1 - 4.6V

OFF

OFF

Fully depressed

More than 1.9 -

4.6V

OFF

ON

SAT014K

SAT971J

SAT014K

SEF949Y

AT-324

[RE4R01A]

DTC P1705 THROTTLE POSITION SENSOR

Wiring Diagram — AT — TPS

ECS007NK

WCWA0154E