Nissan Frontier D22. Instruction — part 735
ON-VEHICLE SERVICE
FSU-15
C
D
F
G
H
I
J
K
L
M
A
B
FSU
3.
Adjust stopper bolt if necessary.
Standard length “L
1
”
(2WD KA24DE model)
: 26.5 mm (1.043 in)
(Length before cap is
mounted)
ASU045
Standard length “L
2
”
(2WD and 4WD VG33E
and VG33ER models)
: Except P265/70R15 tire
26.5 mm (1.043 in)
(Length before cap is
mounted)
: P265/70R15 tire
30.0 mm (1.2 in)
(Length before cap is
mounted)
WSU019
FSU-16
SHOCK ABSORBER
SHOCK ABSORBER
PFP:56210
Removal and Installation
EES000WN
1.
Support lower link with jack.
2.
Remove bolt and nut that hold shock absorber.
3.
Tighten upper nut and lower bolt to specification.
Inspection
EES000WO
Except for nonmetallic parts, clean all parts with suitable solvent and dry with compressed air.
Use compressed air to blow dirt and dust off nonmetallic parts.
●
Check for oil leakage and cracks. Replace if necessary.
●
Check piston rod for cracks, deformation and other damage. Replace if necessary.
●
Check rubber parts for wear, cracks, damage and deformation. Replace if necessary.
Refer to
, or
.
SFA836B
TORSION BAR SPRING
FSU-17
C
D
F
G
H
I
J
K
L
M
A
B
FSU
TORSION BAR SPRING
PFP:54010
Removal
EES000WP
1.
Move dust cover.
2.
Paint matching marks on the torsion bar spring and the corre-
sponding arm.
NOTE:
Always use paint to place the matching mark; do not scribe the
affected parts.
3.
Measure anchor bolt protrusion “L” and remove the lock nut and
adjusting nut.
WARNING:
Before removing the nuts, ensure that twisting force is elim-
inated from the torsion bar springs.
AFA140
ASU047
WSU020
Standard length "L": 68 mm (2.68 in)
WSU021
FSU-18
TORSION BAR SPRING
4.
Remove torsion bar spring.
●
Remove torque arm fixing nuts, then withdraw torsion bar
spring forward with torque arm.
Inspection
EES000WQ
●
Check torsion bar spring for wear, twist, bend and other damage.
●
Check serrations of each part for cracks, wear, twist and other damage.
●
Check dust cover for cracks.
Installation and Adjustment
EES000WR
Adjustment of anchor arm adjusting nut is in tightening direc-
tion only.
Do not adjust by loosening anchor arm adjusting nut.
1.
Coat multi-purpose grease on the serration of torsion bar spring.
2.
Place lower link in the position where bound bumper clearance
“C” is 0.
3.
Install torsion bar spring with torque arm.
NOTE:
Be sure to install right and left torsion bar springs correctly.
4.
While aligning the anchor arm with the matching mark, install the
anchor arm to the torsion bar spring.
WSU022
Clearance "C": 0 mm (0 in)
SFA549
SFA854
ASU051
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст