Nissan Rogue. Instruction — part 192
REPLACEMENT OPERATIONS
BRM-41
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
Rear Side Member Extension
INFOID:0000000011280094
Work after rear panel has been removed.
Replacement parts
z
Rear floor rear
z
Rear floor rear side
Front
AWKIA2865ZZ
BRM-42
< REMOVAL AND INSTALLATION >
REPLACEMENT OPERATIONS
Replacement parts
z
Rear side member extension (LH)
Front
AWKIA2866ZZ
BODY ALIGNMENT
BRM-43
< SERVICE DATA AND SPECIFICATIONS (SDS)
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
SERVICE DATA AND SPECIFICATIONS (SDS)
BODY ALIGNMENT
Body Center Marks
INFOID:0000000011280095
A mark has been placed on each part of the body to indicate the vehicle center. When repairing parts dam-
aged by an accident which might affect the vehicle frame (members, pillars, etc.), more accurate and effective
repair will be possible by using these marks together with body alignment specifications.
Unit: mm (in)
Front
Points
Portion
Marks
A
Cowl top extension
Hole
φ7 (0.28)
B
Center cowl top
Embossment
C
Front roof
Embossment
D
Rear roof
Embossment
AWKIA2867ZZ
BRM-44
< SERVICE DATA AND SPECIFICATIONS (SDS)
BODY ALIGNMENT
Description
INFOID:0000000011280096
• All dimensions indicated in the figures are actual.
• When using a tracking gauge, adjust both pointers to equal length. Then check the pointers and gauge itself
to make sure there is no free play.
• When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
• Measurements should be taken at the center of the mounting holes.
• An asterisk (*) following the value at the measuring point indicates that the measuring point on the other side
is symmetrically the same value.
• The coordinates of the measurement points are the distances measured from the standard line of
″X″, ″Y″
and
″Z″.
•
″Z″: Imaginary base line [200 mm (7.87 in) below datum line (″0Z″ at design plan)]
Engine Compartment
INFOID:0000000011280097
MEASUREMENT
E
Trans control reinforcement
Hole 14
×12 (0.55×0.47)
F
Rear seat crossmember
Embossment
Points
Portion
Marks
1.
Vehicle center
2.
Front axle center
3.
Imaginary base line
JSKIA0073GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст