Nissan Rogue. Instruction — part 188
BODY CONSTRUCTION
BRM-25
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
• Seal up the area around the hemmed end of the flange.
JSKIA0137GB
BRM-26
< REMOVAL AND INSTALLATION >
REPLACEMENT OPERATIONS
REPLACEMENT OPERATIONS
Description
INFOID:0000000011280081
• This section is prepared for technicians who have attained a high level of skill and experience in repairing
collision-damaged vehicles and also use modern service tools and equipment. Persons unfamiliar with body
repair techniques should not attempt to repair collision-damaged vehicles by using this section.
• Technicians are also encouraged to read Body Repair Instruction (Fundamentals) in order to ensure that the
original functions and quality of the vehicle can be maintained. The Body Repair Instruction (Fundamentals)
contains additional information, including cautions and warning, that are not including in this instruction. Techni-
cians should refer to both instructions to ensure proper repairs.
• Please note that these information are prepared for worldwide usage, and as such, certain procedures might
not apply in some regions or countries.
The symbols used in this section for welding operations are shown below.
Symbol marks
Description
2-spot welds
3-spot welds
MIG plug weld
For 3 panels plug weld method
MIG seam weld / Point weld
JSKIA0049ZZ
JSKIA0053ZZ
JSKIA0050ZZ
JSKIA0051ZZ
JSKIA0054ZZ
JSKIA0055ZZ
JSKIA0052ZZ
JSKIA0056ZZ
REPLACEMENT OPERATIONS
BRM-27
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
• Front pillar butt joint can be determined anywhere within shaded
area as shown in the figure. The best location for the butt joint is at
position A due to the construction of the vehicle. Refer to the front
pillar section.
• Determine cutting position and record distance from the locating
indent. Use this distance when cutting the service part. Cut outer
front pillar over 60 mm (2.36 in) above inner front pillar cut position.
• Prepare a cutting jig to make outer pillar easier to cut. Also, this will
permit service part to be accurately cut at joint position.
• An example of cutting operation using a cutting jig is as follows.
1. Mark cutting lines.
A: Cut position of outer pillar
B: Cut position of inner pillar
2. Align cutting line with notch on jig. Clamp jig to pillar.
3. Cut outer pillar along groove of jig (at position A).
4. Remove jig and cut remaining portions.
5. Cut inner pillar at position B in same manner.
Hoodledge
INFOID:0000000011280082
PIIA0150E
JSKIA0104GB
JSKIA0105GB
PIIA0153E
BRM-28
< REMOVAL AND INSTALLATION >
REPLACEMENT OPERATIONS
Hoodledge Reinforcement
INFOID:0000000011280083
.
Replacement parts
z
Upper hoodledge (LH)
Front
ALKIA3272ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст