Nissan Rogue. Instruction — part 995
PWC-62
< SYMPTOM DIAGNOSIS >
POWER WINDOW RETAINED POWER OPERATION DOES NOT OPERATE
PROPERLY
POWER WINDOW RETAINED POWER OPERATION DOES NOT OPER-
ATE PROPERLY
Diagnosis Procedure
INFOID:0000000011278741
1.
CHECK DOOR SWITCH
Check door switch.
Refer to
DLK-156, "Component Function Check"
(with Intelligent Key system) or
(without Intelligent Key system).
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair or replace the malfunctioning parts.
2.
CONFIRM THE OPERATION
Confirm the operation again.
Is the result normal?
YES
>> Check intermittent incident. Refer to
GI-44, "Intermittent Incident"
.
NO
>> GO TO 1.
AUTO OPERATION DOES NOT OPERATE BUT MANUAL OPERATE NORMAL-
LY (DRIVER SIDE)
PWC-63
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
L
M
A
B
PWC
N
O
P
AUTO OPERATION DOES NOT OPERATE BUT MANUAL OPERATE NOR-
MALLY (DRIVER SIDE)
Diagnosis Procedure
INFOID:0000000011278742
1.
PERFORM INITIALIZATION PROCEDURE
Initialization procedure is executed and operation is confirmed.
PWC-28, "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Special
Is the inspection result normal?
YES
>> Inspection End.
NO
>> GO TO 2.
2.
CHECK ENCODER
Check encoder.
PWC-46, "Component Function Check"
.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Repair or replace the malfunctioning parts.
3.
CONFIRM THE OPERATION
Confirm the operation again.
Is the result normal?
YES
>> Check intermittent incident. Refer to
GI-44, "Intermittent Incident"
.
NO
>> GO TO 1.
PWC-64
< SYMPTOM DIAGNOSIS >
POWER WINDOW LOCK SWITCH DOES NOT FUNCTION
POWER WINDOW LOCK SWITCH DOES NOT FUNCTION
Diagnosis Procedure
INFOID:0000000011278743
1.
REPLACE MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH
Replace main power window and door lock/unlock switch.
>> Refer to
PWC-66, "Removal and Installation"
.
MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH
PWC-65
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
PWC
N
O
P
REMOVAL AND INSTALLATION
MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH
Removal and Installation
INFOID:0000000011278744
REMOVAL
1. Remove the front door pull handle bracket (LH). Refer to
2. Release pawls using a suitable tool (A) and remove main power
window and door lock/unlock switch finisher (1).
: Pawl
3. Disconnect the harness connectors from the main power window and door lock/unlock switch.
4. Release the pawls, then separate the main power window and
door lock/unlock switch (1) from the switch finisher (2).
: Pawl
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
When the main power window and door lock/unlock switch is removed or replaced, it is necessary to perform
the initialization procedure. Refer to
PWC-28, "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGA-
.
ALJIA1466ZZ
ALKIA3471ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст