Nissan Rogue. Instruction — part 934
MWI
THE AMBIENT TEMPERATURE DISPLAY IS INCORRECT
MWI-83
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
THE AMBIENT TEMPERATURE DISPLAY IS INCORRECT
Description
INFOID:0000000011279847
• The displayed outside air temperature is higher than the actual temperature.
• The displayed outside air temperature is lower than the actual temperature.
• Outside air temperature is not indicated.
Diagnosis Procedure
INFOID:0000000011279848
1.
CHECK AMBIENT SENSOR SIGNAL CIRCUIT
Check the ambient sensor signal circuit. Refer to
.
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair or replace harness or connector.
2.
CHECK AMBIENT SENSOR
Check the ambient sensor. Refer to
MWI-67, "Component Inspection"
Is the inspection result normal?
YES
>> Replace combination meter. Refer to
MWI-84, "Removal and Installation"
NO
>> Replace ambient sensor. Refer to
MWI-84
< REMOVAL AND INSTALLATION >
COMBINATION METER
REMOVAL AND INSTALLATION
COMBINATION METER
Removal and Installation
INFOID:0000000011279849
REMOVAL
1. Remove the cluster lid A. Refer to
IP-21, "Removal and Installation"
.
2. Remove screws (A), from the combination meter (1).
3. Release the clips and remove the combination meter (1) from
the instrument panel.
: Clips
4. Disconnect the harness connectors from the combination meter
and remove.
INSTALLATION
Installation is in the reverse order of removal.
ALNIA1607ZZ
ALNIA1608ZZ
MWI
METER CONTROL SWITCH
MWI-85
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
METER CONTROL SWITCH
Removal and Installation
INFOID:0000000011279850
REMOVAL
1. Remove the instrument finisher A. Refer to
IP-15, "INSTRUMENT FINISHER A : Removal and Installa-
2. Remove the screws (A) and the meter control switch (1).
INSTALLATION
Installation is in the reverse order of removal.
ALNIA1585ZZ
MWI-86
< UNIT DISASSEMBLY AND ASSEMBLY >
COMBINATION METER
UNIT DISASSEMBLY AND ASSEMBLY
COMBINATION METER
Exploded View
INFOID:0000000011279851
Disassembly and Assembly
INFOID:0000000011279852
CAUTION:
• Do not touch the display, pointer, inside of combination meter or the printed area of the dial during
disassembly or assembly.
• Keep away from magnetic sources.
• Do not damage the combination meter lens.
DISASSEMBLY
1. Remove the combination meter. Refer to
MWI-84, "Removal and Installation"
2. Release pawls and remove the combination meter lens.
ASSEMBLY
Assembly is in the reverse order of disassembly.
1. Combination meter
2.
Combination meter lens
Pawl
ALNIA1609ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст