Nissan Rogue. Instruction — part 1244
WT-52
< SYMPTOM DIAGNOSIS >
TPMS
SYMPTOM DIAGNOSIS
TPMS
Symptom Table
INFOID:0000000011280533
LOW TIRE PRESSURE WARNING LAMP SYMPTOM CHART
Diagnosis items
Symptom
(Ignition switch
ON)
Low tire pressure warning lamp
Cause
Action
Low tire pres-
sure warning
lamp
The low tire pres-
sure warning lamp
illuminates for 1
second, then turns
OFF.
Wake-up operation for all
tire pressure sensors at
wheels is completed.
No system malfunctions
The low tire pres-
sure warning lamp
turns ON and stays
illuminated.
Low tire pressure
Check the tire pressure for
all wheels and adjust to the
specified value. Refer to
.
Tire pressure monitoring
system configuration not
performed.
Perform configuration. Re-
fer to
.
Tire pressure sensor ID
registration not per-
formed.
Perform ID registration. Re-
fer to
.
SEIA0592E
SEIA0598E
TPMS
WT-53
< SYMPTOM DIAGNOSIS >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
Low tire pres-
sure warning
lamp
The low tire pres-
sure warning lamp
repeats blinking at
0.5-second inter-
vals for 1 minute,
and then stays illu-
minated.
The BCM cannot detect
tire pressure data signal.
• Check visually that the
tire pressure sensors are
installed. If necessary, re-
place/install the tire pres-
sure sensor(s) and
perform tire pressure
sensor ID registration.
Refer to
.
• Remove the interference
radio wave (e.g. battery
charger of smart phone).
The combination meter
fuse is open or removed
(or pulled out).
Check and install the com-
bination meter fuse. If nec-
essary, replace the fuse.
The BCM harness con-
nector is removed.
Check the connection con-
ditions of the BCM harness
connector, and repair if nec-
essary.
Tire Pressure Monitoring
System (TPMS) mal-
function.
(except tire pressure
monitoring system con-
figuration and/or tire
pressure sensor ID reg-
istration non-performed)
Perform CONSULT self-di-
agnosis. Refer to
.
Hazard warning
lamp
The hazard warn-
ing lamp does not
blink twice when
performing ID reg-
istration operation.
—
ID registration is not
completed.
Perform “ID REGISTRA-
TION CANNOT BE COM-
PLETED” diagnosis
procedure. Refer to
.
Diagnosis items
Symptom
(Ignition switch
ON)
Low tire pressure warning lamp
Cause
Action
SEIA0788E
WT-54
< SYMPTOM DIAGNOSIS >
LOW TIRE PRESSURE WARNING LAMP DOES NOT TURN ON
LOW TIRE PRESSURE WARNING LAMP DOES NOT TURN ON
Description
INFOID:0000000011378272
The low tire pressure warning lamp does not turn ON when the ignition switch is turned ON.
NOTE:
The low tire pressure warning lamp turn ON for approximately 1 second and then turns OFF when the ignition
switch is turned ON. This is to check that no abnormal condition is present in the tire pressure monitoring sys-
tem.
The combination meter may be malfunctioning or the tire pressure monitoring system may be malfunctioning if
the low tire pressure warning lamp does not turn ON when the ignition switch is turned ON.
Diagnosis Procedure
INFOID:0000000011378273
NOTE:
The Signal Tech II Tool [– (J-50190)] can be used to perform the following functions. Refer to the Signal Tech
II User Guide for additional information.
• Activate and display TPMS sensor IDs
• Display tire pressure reported by the TPMS sensor
• Read TPMS DTCs
• Register TPMS sensor IDs
1.
CHECK LOW TIRE PRESSURE WARNING LAMP SIGNAL
With CONSULT
1. Turn the ignition switch ON.
CAUTION:
Never start the engine.
2. Select “Active Test” in “AIR PRESSURE MONITOR”.
3. Touch “WARNING LAMP” to turn ON the low tire pressure warning lamp.
When “Active Test” is performed, does the low tire pressure warning lamp in the combination meter turn ON?
YES
>> GO TO 2.
NO
>> GO TO 3.
2.
CHECK LOW TIRE PRESSURE WARNING LAMP OPERATION
Check that the low tire pressure warning lamp is turned OFF after turns ON for approximately 1 second, when
the ignition switch is turned ON.
Is the inspection result normal?
YES
>> Check intermittent incident. Refer to
GI-44, "Intermittent Incident"
.
NO
>> Replace the BCM. Refer to
BCS-75, "Removal and Installation"
(with Intelligent Key system) or
BCS-135, "Removal and Installation"
(without Intelligent Key system).
3.
CHECK COMBINATION METER POWER SUPPLY CIRCUIT
Perform the trouble diagnosis for combination meter power supply circuit. Refer to
Is the inspection result normal?
YES
>> Perform combination diagnosis. Refer to
.
NO
>> Repair or replace malfunctioning components.
LOW TIRE PRESSURE WARNING LAMP STAYS ON
WT-55
< SYMPTOM DIAGNOSIS >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
LOW TIRE PRESSURE WARNING LAMP STAYS ON
Description
INFOID:0000000011378268
The low tire pressure warning lamp does not turn OFF after several seconds have passed after engine starts.
Diagnosis Procedure
INFOID:0000000011378269
1.
CHECK TIRE PRESSURE
1. Turn the ignition switch ON.
CAUTION:
Never start the engine.
2. Check the tire pressure for all wheels and adjust to the specified value. Refer to
.
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Inspect or repair the tires or wheels.
2.
CHECK LOW TIRE PRESSURE WARNING LAMP OPERATION
Check that the low tire pressure warning lamp is turned OFF after turns ON for approximately 1 second, when
the ignition switch is turned ON.
Is the inspection result normal?
YES
>> Inspection End.
NO
>> GO TO 3.
3.
PERFORM SELF-DIAGNOSIS
With CONSULT
Perform “Self Diagnostic Result” for “AIR PRESSURE MONITOR”.
Is DTC detected?
YES
>> Perform DTC diagnosis procedure. Refer to
NO
>> GO TO 4.
4.
CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis for power supply and ground circuit. Refer to
(with Intelligent Key system) or
WT-50, "WITHOUT INTELLIGENT KEY
(without Intelligent Key system).
Is the inspection result normal?
YES
>> Replace BCM. Refer to
BCS-75, "Removal and Installation"
(with Intelligent Key system) or
135, "Removal and Installation"
(without Intelligent Key system).
NO
>> Repair or replace malfunctioning components.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст