Nissan Rogue. Instruction — part 660
FRONT FOG LAMP
EXL-269
< REMOVAL AND INSTALLATION >
[LED HEADLAMP]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
FRONT FOG LAMP
Exploded View
INFOID:0000000011280913
Removal and Installation
INFOID:0000000011280914
REMOVAL
1. Partially remove front fender protector.
2. Disconnect the harness connector from the front fog lamp.
3. Remove front fog lamp bolts and front fog lamp.
INSTALLATION
Installation in the reverse order of removal.
NOTE:
After installation, perform front fog lamp aiming adjustment. Refer to
EXL-117, "Aiming Adjustment Proce-
.
Bulb Replacement
INFOID:0000000011280915
WARNING:
Do not touch bulb by hand while it is lit or right after being turned off. Burning may result.
CAUTION:
• Do not touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to pre-
vent damage to the bulb.
1.
Front bumper fascia
2.
Front fog lamp
3.
Front fog lamp bulb
Front
AWLIA2317ZZ
EXL-270
< REMOVAL AND INSTALLATION >
[LED HEADLAMP]
FRONT FOG LAMP
• Do not leave bulb out of lamp reflector for a long time because dust, moisture smoke, etc. may affect
the performance of lamp. When replacing bulb, be sure to replace it with new one.
REMOVAL
1. Partially remove front fender protector. Refer to
EXT-28, "FENDER PROTECTOR : Exploded View"
2. Disconnect the harness connector from the front fog lamp (A).
3. Rotate bulb (1) counterclockwise and remove.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installing the bulb, install the bulb socket securely for watertightness.
AWLIA2050ZZ
OPTICAL SENSOR
EXL-271
< REMOVAL AND INSTALLATION >
[LED HEADLAMP]
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
OPTICAL SENSOR
Exploded View
INFOID:0000000011372324
Removal and Installation
INFOID:0000000011280916
REMOVAL
1. Release the optical sensor (2) from defroster grille (1) using a
suitable tool.
2. Disconnect the harness connector (A) from the optical sensor
(2) and remove.
INSTALLATION
Installation is in the reverse order of removal.
1.
Optical sensor
2.
Defroster grille
Pawl
ALLIA1590ZZ
AWLIA2487ZZ
EXL-272
< REMOVAL AND INSTALLATION >
[LED HEADLAMP]
COMBINATION SWITCH
COMBINATION SWITCH
Exploded View
INFOID:0000000011280917
Removal and Installation
INFOID:0000000011280918
REMOVAL
1. Remove the steering angle sensor. Refer to
BRC-137, "Removal and Installation"
.
2. Disconnect harness connector from combination switch.
3. Remove screw (A) and combination switch (1).
INSTALLATION
Installation is in the reverse order of removal.
1.
Combination switch
2. Steering column
A. Screw
Front
AWMIA1520ZZ
AWMIA0709ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст