Nissan Rogue. Instruction — part 17
AV-60
< DTC/CIRCUIT DIAGNOSIS >
[DISPLAY AUDIO]
USB CONNECTOR
USB CONNECTOR
Diagnosis Procedure
INFOID:0000000011276756
Regarding Wiring Diagram information, refer to
1.
CHECK USB INTERFACE HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect audio unit connector M121 and USB interface connector M89.
3. Check continuity between audio unit connector M121 and USB interface connector M89.
4. Check continuity between audio unit connector M121 and ground.
Is the inspection result normal?
YES
>> Replace the USB interface. Refer to
AV-72, "Removal and Installation"
.
NO
>> Repair or replace harness or connectors.
Audio unit
USB interface
Continuity
Connector
Terminal
Connector
Terminal
M121
61
M89
1
Yes
62
2
63
3
65
5
66
6
Audio unit
—
Continuity
Connector
Terminal
M121
61
Ground
No
63
AV
AUXILIARY INPUT JACK
AV-61
< DTC/CIRCUIT DIAGNOSIS >
[DISPLAY AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
AUXILIARY INPUT JACK
Diagnosis Procedure
INFOID:0000000011276757
Regarding Wiring Diagram information, refer to
1.
CHECK AUX JACK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect audio control unit connector M88 and AUX in jack connector M104.
3. Check continuity between audio control unit connector M88 and AUX in jack connector M104.
4. Check continuity between audio control unit connector M88 and ground.
Is the inspection result normal?
YES
>> Replace the AUX in jack. Refer to
AV-72, "Removal and Installation"
NO
>> Repair or replace harness or connectors.
Audio control unit
AUX in jack
Continuity
Connector
Terminal
Connector
Terminal
M88
21
M104
1
Yes
22
4
23
3
Audio control unit
—
Continuity
Connector
Terminal
M88
21
Ground
No
22
AV-62
< SYMPTOM DIAGNOSIS >
[DISPLAY AUDIO]
AUDIO SYSTEM
SYMPTOM DIAGNOSIS
AUDIO SYSTEM
Symptom Table
INFOID:0000000011276758
RELATED TO AUDIO
Symptoms
Check items
Probable malfunction location
The disk cannot be removed.
Audio unit
Malfunction in audio unit.
Refer to
AV-19, "On Board Diagnosis Func-
No sound comes out or the level of the
sound is low.
No sound from all speakers.
• Speaker circuit shorted to ground.
.
• Audio unit power supply and ground cir-
Only a certain speaker (front tweeter LH,
front tweeter RH, front door speaker LH,
front door speaker RH, rear door speaker
LH, rear door speaker RH) does not output
sound.
• Poor connector connection of speaker.
• Sound signal circuit malfunction between
audio unit and speaker.
Refer to:
-
tweeter).
-
(front door
speaker).
-
(rear door
speaker).
• Malfunction in speaker.
Refer to:
-
AV-69, "Removal and Installation"
(front
tweeter).
-
AV-70, "Removal and Installation"
(front
door speaker).
-
AV-71, "Removal and Installation"
(rear
door speaker).
• Malfunction in audio unit.
AV
AUDIO SYSTEM
AV-63
< SYMPTOM DIAGNOSIS >
[DISPLAY AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
RELATED TO HANDS-FREE PHONE
• Before performing diagnosis, confirm that the cellular phone being used by the customer is compatible with
the vehicle.
• It is possible that a malfunction is occurring due to a version change of the phone even though the phone is
a compatible type. This can be confirmed by changing the cellular phone to another compatible type, and
check that it operates normally. It is important to determine whether the cause of the malfunction is the vehi-
cle or the cellular phone.
Check Compatibility
1. Make sure the customer’s Bluetooth
®
related concern is understood.
2. Verify the customer’s concern.
NOTE:
The customer’s phone may be required, depending upon their concern.
3. Write down the customer’s phone brand, model and service provider.
NOTE:
Noise is mixed with audio.
Noise comes out from all speakers.
Malfunction in audio unit.
Refer to
AV-19, "On Board Diagnosis Func-
.
Noise comes out only from a certain speak-
er (front tweeter LH, front tweeter RH, front
door speaker LH, front door speaker RH,
rear door speaker LH, rear door speaker
RH).
• Poor connector connection of speaker.
• Sound signal circuit malfunction between
audio unit and speaker.
Refer to:
-
(front
tweeter).
-
(front door
speaker).
-
(rear door
speaker).
• Malfunction in speaker.
• Poor Installation of speaker (e.g. back-
lash and looseness).
Refer to:
-
AV-69, "Removal and Installation"
tweeter).
-
AV-70, "Removal and Installation"
door speaker).
-
AV-71, "Removal and Installation"
door speaker).
• Malfunction in audio unit.
Refer to
.
Noise is mixed with radio only (when the ve-
hicle hits a bump or while driving over bad
roads)
Poor connector connection of antenna or
antenna feeder.
Refer to
.
No radio reception or poor reception.
• Other audio sounds are normal.
• Any radio station cannot be received or
poor reception is caused even after mov-
ing to a service area with good reception
(e.g. a place with clear view and no ob-
stacles generating external noises).
• Antenna amp. ON signal circuit malfunc-
tion.
Refer to
• Poor connector connection of antenna or
antenna feeder.
Refer to
.
No satellite radio reception.
Satellite radio antenna malfunction.
• Poor continuity in antenna feeder.
• Poor connector connection of antenna or
antenna feeder.
• Loose satellite radio antenna mounting
nut.
Refer to
.
Buzz/rattle sound from speaker
The majority of buzz/rattle sounds are not
indicative of an issue with the speaker, usu-
ally something nearby the speaker is caus-
ing the buzz/rattle.
Refer to "SQUEAK AND RATTLE TROU-
BLE DIAGNOSIS" in the appropriate interi-
or trim section.
Symptoms
Check items
Probable malfunction location
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст