Nissan Rogue. Instruction — part 1133
SRC-82
< DTC/CIRCUIT DIAGNOSIS >
B0097 REAR SIDE AIR BAG SATELLITE SENSOR RH
B0097 REAR SIDE AIR BAG SATELLITE SENSOR RH
Description
INFOID:0000000011279582
DTC B0097 REAR SATELLITE SENSOR RH
The rear side air bag satellite sensor RH is wired to the air bag diagnosis sensor unit. The air bag diagnosis
sensor unit will monitor the rear side air bag satellite sensor RH for internal failures and its circuits for commu-
nication errors.
PART LOCATION
SRC-5, "Component Parts Location"
.
DTC Logic
INFOID:0000000011279583
DTC DETECTION LOGIC
With CONSULT
DTC CONFIRMATION PROCEDURE (With CONSULT)
1.
CHECK SELF DIAGNOSTIC RESULT
1. Turn ignition switch ON.
2. Check for DTC using CONSULT.
Is the DTC detected?
YES (Current DTC)>>Refer to
YES (Past DTC)>>GO TO 2.
NO
>> Inspection End.
2.
ERASE SELF DIAGNOSTIC RESULT
Erase the DTC using CONSULT.
Can the DTC be erased?
YES
>> Inspection End.
NO
>> Refer to
DTC CONFIRMATION PROCEDURE (Without CONSULT)
1.
CHECK SELF DIAGNOSTIC RESULT
1. Turn ignition switch ON.
2. Check the air bag warning lamp status. Refer to
SRC-14, "On Board Diagnosis Function"
NOTE:
SRS will not enter diagnosis mode if no malfunction is detected in user mode.
Is the DTC detected?
YES
>> Refer to
NO
>> Inspection End.
CONSULT name
DTC
DTC detecting condition
Repair order
C-PILLAR SATELLITE SENSOR RH
[SENSOR FAIL]
B0097
Rear side satellite sensor RH has mal-
functioned.
Refer to
C-PILLAR SATELLITE SENSOR RH
[COMM FAIL]
Rear side satellite sensor RH communi-
cation error.
C-PILLAR SATELLITE SENSOR RH
[DISCONNECT]
Rear side satellite sensor RH is discon-
nected.
C-PILLAR SATELLITE SENSOR RH
[UNMATCH]
Rear side satellite sensor RH is out of
specification.
C-PILLAR SATELLITE SENSOR RH
[GND-SHORT]
Rear side satellite sensor RH circuit is
shorted to ground.
B0097 REAR SIDE AIR BAG SATELLITE SENSOR RH
SRC-83
< DTC/CIRCUIT DIAGNOSIS >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
Diagnosis Procedure
INFOID:0000000011279584
1.
HARNESS CONNECTOR
Visually inspect all applicable harness connectors for the following:
• Visible damage to connector or terminal
• Loose terminal
• Poor connection
NOTE:
All harness connectors should be inspected from the air bag diagnosis sensor unit to the end component
(including any in-line connectors).
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Perform one of the following repairs:
• Visible damage: Replace the harness.
• Loose terminal: Secure the terminal.
• Poor connection: Secure the connection.
2.
CONFIRM DTC
1. Reconnect all harness connectors.
2. Turn ignition switch ON.
3. Check for DTC using CONSULT.
Is DTC still current?
YES
>> GO TO 3.
NO
>> Refer to
GI-44, "Intermittent Incident"
.
3.
WIRING HARNESS
Check the wiring harness for visible damage.
NOTE:
The entire wiring harness should be inspected from the air bag diagnosis sensor unit to the end component
(including any in-line connectors).
Is the inspection result normal?
YES
>> GO TO 4.
NO
>> Replace the harness.
4.
CONFIRM DTC
1. Reconnect all harness connectors.
2. Turn ignition switch ON.
3. Check for DTC using CONSULT.
Is DTC still current?
YES
>> GO TO 5.
NO
>> Refer to
GI-44, "Intermittent Incident"
.
5.
REAR SIDE SATELLITE SENSOR RH
1. Replace the rear side satellite sensor RH. Refer to
SR-24, "Removal and Installation"
.
2. Turn ignition switch ON.
3. Check for DTC using CONSULT.
Is DTC still current?
YES
>> GO TO 6.
NO
>> Clear DTC. Inspection End.
6.
AIR BAG DIAGNOSIS SENSOR UNIT
1. Replace the air bag diagnosis sensor unit. Refer to
SR-26, "Removal and Installation"
2. Turn ignition switch ON.
3. Check for DTC using CONSULT.
Is DTC still current?
YES
>> GO TO 7.
NO
>> Clear DTC. Inspection End.
SRC-84
< DTC/CIRCUIT DIAGNOSIS >
B0097 REAR SIDE AIR BAG SATELLITE SENSOR RH
7.
RELATED HARNESS
Replace the related harness.
>> END
B00A0 OCS SYSTEM
SRC-85
< DTC/CIRCUIT DIAGNOSIS >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
B00A0 OCS SYSTEM
Description
INFOID:0000000011279585
DTC B1017, B1018, B1020, B1021, B1022, B1025, B1032, B1048 OCCUPANT CLASSIFICATION
SYSTEM (OCS)
The OCS control unit is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will mon-
itor the OCS for failures and interruptions in communication between the OCS control unit and the air bag
diagnosis sensor unit.
PART LOCATION
SRC-5, "Component Parts Location"
.
DTC Logic
INFOID:0000000011279586
DTC DETECTION LOGIC
With CONSULT
DTC CONFIRMATION PROCEDURE (With CONSULT)
1.
CHECK SELF DIAGNOSTIC RESULT
1. Turn ignition switch ON.
2. Check for DTC using CONSULT.
Is the DTC detected?
YES (Current DTC)>>Refer to
YES (Past DTC)>>GO TO 2.
NO
>> Inspection End.
2.
ERASE SELF DIAGNOSTIC RESULT
Erase the DTC using CONSULT.
Can the DTC be erased?
YES
>> Inspection End.
NO
>> Refer to
DTC CONFIRMATION PROCEDURE (Without CONSULT)
1.
CHECK SELF DIAGNOSTIC RESULT
1. Turn ignition switch ON.
2. Check the air bag warning lamp status. Refer to
SRC-14, "On Board Diagnosis Function"
.
CONSULT name
DTC
DTC detecting condition
Repair order
OCCUPANT DETECTION SENSOR UNIT
[UNIT FAIL]
B00A0
The OCS control unit is malfunction-
ing.
Refer to
OCCUPANT DETECTION SENSOR UNIT
[NO DATA]
OCCUPANT DETECTION SENSOR UNIT
[UNDEFINED]
OCCUPANT DETECTION SENSOR UNIT
[RESET FAIL]
OCCUPANT DETECTION SENSOR
[UNIT FAIL]
The OCS sensor is malfunctioning.
OCCUPANT DETECTION SENSOR
[POWER FAIL]
The OCS sensor circuit is malfunc-
tioning.
OCCUPANT DETECTION SENSOR UNIT
[COMM FAIL]
Communication between the OCS
control unit and the air bag diagnosis
sensor unit is interrupted.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст