Nissan Rogue. Instruction — part 1259
FRONT WIPER AUTO STOP SIGNAL CIRCUIT
WW-39
< DTC/CIRCUIT DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
YES
>> Replace front wiper motor. Refer to
WW-69, "Removal and Installation"
NO
>> Repair or replace harness.
WW-40
< DTC/CIRCUIT DIAGNOSIS >
FRONT WIPER MOTOR GROUND CIRCUIT
FRONT WIPER MOTOR GROUND CIRCUIT
Diagnosis Procedure
INFOID:0000000011280398
Regarding Wiring Diagram information, refer to
.
1.
CHECK FRONT WIPER MOTOR GROUND CIRCUIT
1. Turn the ignition switch OFF.
2. Disconnect front wiper motor.
3. Check continuity between front wiper motor harness connector and ground.
Is the inspection result normal?
YES
>> Front wiper motor ground circuit is normal.
NO
>> Repair or replace harness.
Front wiper motor
Ground
Continuity
Connector
Terminal
E20
2
Yes
WASHER MOTOR CIRCUIT
WW-41
< DTC/CIRCUIT DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
WASHER MOTOR CIRCUIT
Diagnosis Procedure
INFOID:0000000011280399
Regarding Wiring Diagram information, refer to
.
1.
CHECK FRONT AND REAR WASHER MOTOR FUSE
1. Turn the ignition switch OFF.
2. Check that the following fuse is not blown:
Is the fuse blown?
YES
>> Replace the blown fuse after repairing the affected circuit.
NO
>> GO TO 2.
2.
CHECK FRONT AND REAR WASHER MOTOR POWER SUPPLY
1. Disconnect front and rear washer motor.
2. Turn ignition switch ON.
3. Check voltage between front and rear washer motor harness connector and ground.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Repair or replace the harness or connectors.
3.
CHECK FRONT AND REAR WASHER MOTOR CIRCUIT CONTINUITY
1. Turn the ignition switch OFF.
2. Disconnect combination switch (wiper and washer switch).
3. Check continuity between combination switch (wiper and washer switch) harness connector and front and
rear washer motor.
Is the inspection result normal?
YES
>> GO TO 4.
NO
>> Repair or replace the harness or connectors.
4.
CHECK WIPER AND WASHER SWITCH GROUND CIRCUIT
Check continuity between combination switch (wiper and washer switch) harness connector and ground.
Is the inspection result normal?
YES
>> GO TO 5.
NO
>> Repair or replace the harness or connectors.
5.
CHECK WIPER AND WASHER SWITCH
Check wiper and washer switch. Refer to
.
Unit
Location
Fuse No.
Capacity
Front and rear washer motor
Fuse block (J/B)
33
15A
Front and rear washer motor
Ground
Voltage
(Approx.)
Connector
Terminal
E41
1
Battery voltage
Combination switch (wiper and washer switch)
Front and rear washer motor
Continuity
Connector
Terminal
Connector
Terminal
M28
11
E41
1
Yes
Combination switch (wiper and washer switch)
Ground
Continuity
Connector
Terminal
M28
16
Yes
WW-42
< DTC/CIRCUIT DIAGNOSIS >
WASHER MOTOR CIRCUIT
Is the inspection result normal?
YES
>> Replace front and rear washer motor. Refer to
WW-56, "Removal and Installation"
NO
>> Replace wiper and washer switch. Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст