Nissan Titan A60. Instruction — part 543
ON-VEHICLE SERVICE
FSU-9
< PERIODIC MAINTENANCE >
C
D
F
G
H
I
J
K
L
M
A
B
FSU
N
O
P
• Any turning angles are not adjustable. If any of steering angles are out of the specification, check if the
following parts are worn or damaged.
- Steering gear
- Steering column
- Front suspension components
If found that they are worn or damaged, replace them with new ones.
FSU-10
< PERIODIC MAINTENANCE >
UPPER BALL JOINT AND LOWER BALL JOINT
UPPER BALL JOINT AND LOWER BALL JOINT
Inspection
INFOID:0000000006161670
• Check the ball joint for excessive play. Replace the upper or lower link assembly if any of the following
exists:
- Ball joint stud is worn.
- Ball joint is hard to swing.
- Ball joint play in axial directions or end play is excessive.
Swinging Force
NOTE:
Before checking the axial forces and end play, turn the lower ball joint at least 10 revolutions so that the ball
joint is properly broken in.
1. Measure the ball joint swinging force using a suitable tool.
• Measure at the cotter pin hole for upper ball joint as shown.
• Measure at the groove for lower ball joint as shown.
2. Verify the ball joint swinging force is within specification.
Turning Force
NOTE:
Before checking the axial forces and end play, turn the lower ball joint at least 10 revolutions so that the ball
joint is properly broken in.
Vertical End Play
Check dust cover for damage. Replace it and the cover clamp if necessary.
NOTE:
WEIA0076E
Swinging force (A)
Upper ball joint
.
Lower ball joint
: Refer to
.
SFA858A
Turning torque (B)
: Refer to
.
SFA858A
UPPER BALL JOINT AND LOWER BALL JOINT
FSU-11
< PERIODIC MAINTENANCE >
C
D
F
G
H
I
J
K
L
M
A
B
FSU
N
O
P
Before checking the axial forces and end play, turn the lower ball
joint at least 10 revolutions so that the ball joint is properly broken in.
Vertical end play (C)
: Refer to
SFA858A
FSU-12
< PERIODIC MAINTENANCE >
KNUCKLE
KNUCKLE
On-Vehicle Inspection and Service
INFOID:0000000006161671
Make sure the mounting conditions (looseness, backlash) of each component and component status (wear,
damage) are within specifications. Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст