Nissan Titan A60. Instruction — part 959
TM-224
< UNIT DISASSEMBLY AND ASSEMBLY >
DISASSEMBLY
DISASSEMBLY
Disassembly
INFOID:0000000006159464
CAUTION:
Do not disassemble parts behind Drum Support. Refer to
TM-9, "Cross-Sectional View (2WD models)"
.
1. Drain A/T fluid through drain plug.
2. Remove torque converter by holding it firmly and turing while
pulling straight out.
3. Check torque converter one-way clutch using a check tool as
shown.
a. Insert a check tool into the groove of bearing support built into
one-way clutch outer race.
b. While holding bearing support with a check tool, rotate one-way
clutch spline using suitable tool.
c.
Make sure that inner race rotates clockwise only. If not, replace
torque converter assembly.
4. Remove bolts and converter housing from transmission case.
CAUTION:
Do not scratch converter housing.
• Self-sealing bolt (A)
SCIA5010E
SCIA3171E
WCIA0662E
DISASSEMBLY
TM-225
< UNIT DISASSEMBLY AND ASSEMBLY >
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
5. Remove O-ring from input clutch assembly.
6. Remove oil pump assembly to transmission case bolts.
7. Remove the oil pump assembly evenly from the transmission
case using Tools.
CAUTION:
• Fully tighten the sliding hammer screws.
• Make sure that bearing race is installed to the oil pump
assembly edge surface.
8. Remove O-ring from oil pump assembly.
SCIA5011E
SCIA2300E
Tool number
: ST25850000 (J-25721-A)
SCIA5474E
SCIA5172E
TM-226
< UNIT DISASSEMBLY AND ASSEMBLY >
DISASSEMBLY
9. Remove bearing race from oil pump assembly.
10. Remove needle bearing from front sun gear.
11. Remove front sun gear assembly from front carrier assembly.
NOTE:
Remove front sun gear by rotating it left and right.
12. Remove seal rings from input clutch assembly.
13. Remove front carrier assembly (with input clutch assembly and
rear internal gear) from rear carrier assembly.
CAUTION:
Do not remove it with needle bearing.
SCIA6529E
SCIA2808E
SCIA5014E
SCIA2470E
SCIA5015E
DISASSEMBLY
TM-227
< UNIT DISASSEMBLY AND ASSEMBLY >
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
14. Loosen lock nut and remove band servo anchor end pin from
transmission case.
15. Remove brake band from transmission case.
CAUTION:
• To prevent brake linings from cracking or peeling, do not
stretch the flexible band unnecessarily. When removing
the brake band, always secure it with a clip as shown.
• Check brake band facing for damage, cracks, wear or
burns.
16. Remove mid carrier assembly and rear carrier assembly as a
unit.
SCIA6512E
SCIA2580E
SAT655
SCIA5017E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст