Nissan Titan A60. Instruction — part 685
LAN-36
< HOW TO USE THIS MANUAL >
[CAN]
HOW TO USE THIS SECTION
HOW TO USE THIS MANUAL
HOW TO USE THIS SECTION
Caution
INFOID:0000000006179109
• This section describes information peculiar to a vehicle, sheets for trouble diagnosis, and inspection proce-
dures.
• For trouble diagnosis procedure, refer to
LAN-14, "Trouble Diagnosis Procedure"
.
Abbreviation List
INFOID:0000000006179110
Abbreviations in CAN communication signal chart, and the diagnosis sheet are as per the following list.
Abbreviation
Unit name
SELECT SYSTEM
(CONSULT-III)
CAN DIAG SUPPORT MNTR
(CONSULT-III)
4WD
Transfer control unit
ALL MODE AWD/4WD
AWD/4WD
A-BAG
Air bag diagnosis sensor unit
AIR BAG
—
ABS
ABS actuator and electric unit (control unit)
ABS
VDC/TCS/ABS
ADP
Driver seat control unit
AUTO DRIVE POS.
—
BCM
BCM
BCM
BCM/SEC
DIFF
Differential lock control unit
DIFF LOCK
—
DISP
Display control unit
—
DISPLAY
DLC
Data link connector
—
—
ECM
ECM
ENGINE
ECM
HVAC
Front air control
HVAC
—
IPDM-E
IPDM E/R
IPDM E/R
IPDM E/R
M&A
Combination meter
METER/M&A
METER/M&A
STRG
Steering angle sensor
—
STRG
TCM
TCM
TRANSMISSION
TCM
LAN
PRECAUTIONS
LAN-37
< PRECAUTION >
[CAN]
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
INFOID:0000000006179111
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SR and SB section of this Service Man-
ual.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the SR section.
• Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Instruction. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har-
ness connectors.
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
• When working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors with the Igni-
tion ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s) with a
hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing
serious injury.
• When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the
battery, and wait at least 3 minutes before performing any service.
Precautions for Trouble Diagnosis
INFOID:0000000006179112
CAUTION:
• Never apply 7.0 V or more to the measurement terminal.
• Use a tester with open terminal voltage of 7.0 V or less.
• Turn the ignition switch OFF and disconnect the battery cable from the negative terminal when
checking the harness.
Precautions for Harness Repair
INFOID:0000000006179113
• Solder the repaired area and wrap tape around the soldered area.
NOTE:
A fray of twisted lines must be within 110 mm (4.33 in).
SKIB8766E
LAN-38
< PRECAUTION >
[CAN]
PRECAUTIONS
• Bypass connection is never allowed at the repaired area.
NOTE:
Bypass connection may cause CAN communication error. The
spliced wire becomes separated and the characteristics of twisted
line are lost.
• Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communica-
tion line.
SKIB8767E
LAN
DIAGNOSIS AND REPAIR WORKFLOW
LAN-39
< BASIC INSPECTION >
[CAN]
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
BASIC INSPECTION
DIAGNOSIS AND REPAIR WORKFLOW
Interview Sheet
INFOID:0000000006179114
Data Sheet
INFOID:0000000006179115
ON-BOARD DIAGNOSIS COPY SHEET
SKIB8898E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст