Nissan Titan A60. Instruction — part 962
TM-236
< UNIT DISASSEMBLY AND ASSEMBLY >
DISASSEMBLY
48. Remove output speed sensor (1) from transmission case.
CAUTION:
• Do not subject it to impact by dropping or hitting it.
• Do not disassemble.
• Do not allow metal filings or any foreign material to get on
the sensor's front edge magnetic area.
• Do not place in an area affected by magnetism.
49. Remove reverse brake snap ring using two flat-bladed screw-
drivers.
NOTE:
Press out snap ring from the transmission case oil pan side gap
using a flat-bladed screwdriver, and remove it using a another
screwdriver.
50. Remove reverse brake retaining plate from transmission case.
• Check facing for burns, cracks or damage. If necessary,
replace the plate.
51. Remove N-spring from transmission case.
52. Remove reverse brake drive plates, driven plates and dish plate
from transmission case.
• Check facing for burns, cracks or damage. If necessary,
replace the plate.
53. Remove snap ring using suitable tool.
: Bolt
JSDIA1321ZZ
SCIA5032E
SCIA5214E
SCIA2322E
SCIA2323E
DISASSEMBLY
TM-237
< UNIT DISASSEMBLY AND ASSEMBLY >
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
54. Remove spring retainer and return spring from transmission
case.
55. Remove seal rings from drum support.
56. Remove needle bearing from drum support edge surface.
57. Remove reverse brake piston from transmission case using
compressed air. Refer to
.
CAUTION:
Care should be taken not to abruptly blow air. It makes the
piston incline, and as a result, it becomes hard to disas-
semble the pistons.
SCIA2324E
SCIA3333E
SCIA2796E
SCIA5047E
TM-238
< UNIT DISASSEMBLY AND ASSEMBLY >
DISASSEMBLY
58. Remove D-rings from reverse brake piston.
59. Knock out retaining pin using suitable tool.
60. Remove instruction shaft retaining pin using suitable tool.
61. Remove instruction plate (with parking rod) from manual shaft.
62. Remove parking rod from instruction plate.
SCIA6330E
SCIA2328E
SCIA2329E
SCIA5715E
SCIA5220E
DISASSEMBLY
TM-239
< UNIT DISASSEMBLY AND ASSEMBLY >
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
63. Remove instruction shaft from transmission case.
64. Remove instruction shaft oil seals using suitable tool.
CAUTION:
Do not scratch transmission case.
65. Remove detent spring and spacer from transmission case.
66. Remove snap ring from transmission case using suitable tool.
67. Remove servo assembly (with return spring) from transmission
case.
SCIA5716E
SCIA2331E
SCIA5248E
SCIA2333E
SCIA5679E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст