Nissan Titan A60. Instruction — part 537
FL-4
< PREPARATION >
PREPARATION
PREPARATION
PREPARATION
Special Service Tool
INFOID:0000000006164619
The actual shapes of the Kent-Moore tools may differ from those of the special tools illustrated here.
Commercial Service Tool
INFOID:0000000006164620
Tool number
(Kent-Moore No.)
Tool name
Description
—
(J-46536)
Fuel tank lock ring tool
Removing and installing fuel tank lock ring
LBIA0398E
Tool name
Description
Power tool
Loosening bolts and nuts
PBIC0190E
FUEL SYSTEM
FL-5
< BASIC INSPECTION >
C
D
E
F
G
H
I
J
K
L
M
A
FL
N
P
O
BASIC INSPECTION
FUEL SYSTEM
Checking Fuel Line
INFOID:0000000006164621
Inspect fuel lines, fuel filler cap and fuel tank for improper attach-
ment, leaks, cracks, damage, loose connections, chafing or deterio-
ration.
If necessary, repair or replace damaged parts.
SMA803A
FL-6
< UNIT REMOVAL AND INSTALLATION >
FUEL TANK
UNIT REMOVAL AND INSTALLATION
FUEL TANK
Removal and Installation
INFOID:0000000006164622
REMOVAL
WARNING:
Follow the “General Precautions” before working on the fuel system. Refer to
.
1.
Fuel line pump protector
2.
Lock ring
3.
Fuel level sensor, fuel filter, and fuel
pump assembly
4.
Fuel tank
5.
Fuel tank protector
6.
Fuel tank protector clips
7.
Fuel tank straps
8.
O-ring
9.
Fuel filler hose
10. Fuel filler pipe
11.
Fuel filler hose grommet
12. Fuel filler cap
13. Fuel tank shield
AWBIA0882GB
FUEL TANK
FL-7
< UNIT REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
M
A
FL
N
P
O
1. Remove the fuel filler cap to release the pressure from inside the fuel tank.
2. Check the fuel level on level gauge. If the fuel gauge indicates
more than the level as shown (full or almost full), drain the fuel
from the fuel tank until the fuel gauge indicates the level as
shown, or less.
• If the fuel pump does not operate, use the following procedure
to drain the fuel to the specified level.
a. Insert a suitable hose of less than 15 mm (0.59 in) diameter into
the fuel filler pipe through the fuel filler opening to drain the fuel
from fuel filler pipe.
b. Remove the LH rear wheel and tire. Refer to
.
c. Remove the fuel filler pipe shield.
d. Disconnect the fuel filler hose from the fuel filler pipe and dis-
connect the vent hose quick connector.
e. Insert a suitable hose into the fuel tank through the fuel filler
hose to drain the fuel from the fuel tank.
3. Release the fuel pressure from the fuel lines. Refer to
4. Disconnect the battery negative terminal.
5. Remove the three nuts and remove fuel line pump protector.
6. Disconnect the EVAP hose at the EVAP canister.
WBIA0390E
LBIA0437E
LBIA0386E
LBIA0405E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст