Nissan Note E12. Instruction — part 105
CHG-22
< SYMPTOM DIAGNOSIS >
CHARGING SYSTEM
SYMPTOM DIAGNOSIS
CHARGING SYSTEM
Symptom Table
INFOID:0000000009014847
Symptom
Reference
Battery discharged
CHG-10, "Work Flow (With EXP-800 NI or GR8-1200 NI)"
CHG-13, "Work Flow (Without EXP-800 NI or GR8-1200 NI)"
The charge warning lamp does not illuminate when the ignition
switch is set to ON.
The charge warning lamp does not turn OFF after the engine
starts.
The charging warning lamp turns ON when increasing the engine
speed.
CHG
GENERATOR
CHG-23
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
REMOVAL AND INSTALLATION
GENERATOR
Exploded View
INFOID:0000000009385611
Removal and Installation
INFOID:0000000009385612
REMOVAL
1. Disconnect the battery cable from the negative terminal. Refer to
2. Remove the radiator core support upper.
DLK-122, "RADIATOR CORE SUPPORT UPPER : Removal
3. Remove drive belt. Refer to
.
4. Disconnect generator harness connector.
5. Remove “B” terminal nut and disconnect “B” terminal harness.
6. Remove the generator bolts.
7. Remove the generator.
CAUTION:
Be careful not to damage surrounding parts when removing generator from the vehicle.
8. Remove bolts and remove generator bracket if necessary.
INSTALLATION
1. Install the generator bracket (if removed), using the following
procedure.
a. Temporarily tighten bolt (1).
b. Temporarily tighten bolt (2).
c. Tighten bolts to specification in numerical order as shown.
1.
Generator bracket
2.
Tensioner Idler pulley
3.
Generator
4.
“B” terminal harness
5.
Generator harness connector
AWGIA0293ZZ
JMMIA0463ZZ
CHG-24
< REMOVAL AND INSTALLATION >
GENERATOR
2. Install the generator using the following procedure.
a. Temporarily tighten the generator bolts in order from the lower to the upper.
b. Tighten the generator bolts to the specification starting with the top bolt.
c.
Install “B” terminal harness and "B" terminal nut.
CAUTION:
Be sure to tighten "B" terminal nut carefully.
Installation of the remaining components is the reverse order of removal.
CHG
SERVICE DATA AND SPECIFICATIONS (SDS)
CHG-25
< SERVICE DATA AND SPECIFICATIONS (SDS)
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Generator
INFOID:0000000009385613
* : Always check with the Parts Department for the latest parts information.
Model*
A002TJ1791ZC
Manufacturer
Mitsubishi
Nominal rating
13.5V - 110A
Ground polarity
Negative
Minimum revolution under no-load
1,000 rpm
Hot output current (When 13.5 V is applied)
More than 27A/1,300 rpm
More than 95A/2,500 rpm
More than 116A/5,000 rpm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст