Nissan Note E12. Instruction — part 129
DLK-20
< SYSTEM DESCRIPTION >
SYSTEM (INTELLIGENT KEY SYSTEM)
DOOR LOCK FUNCTION
DOOR LOCK FUNCTION : System Description
INFOID:0000000009516519
SYSTEM DIAGRAM
DOOR REQUEST SWITCH OPERATION
When pressing the request switch, it is possible to lock and unlock the door by carrying the Intelligent Key.
OPERATION DESCRIPTION
• When the BCM detects that each door request switch is pressed, it starts the outside key antenna and inside
key antenna corresponding to the pressed door request switch and transmits the request signal to the Intelli-
gent Key. And then, check that the Intelligent Key is near the door.
• If the Intelligent Key is within the outside key antenna detection area, it receives the request signal and
transmits the key ID signal to the BCM via remote keyless entry receiver.
• BCM receives the key ID signal and compares it with the registered key ID.
• BCM transmits door lock/unlock signal and operates each door lock actuator. At the same time, BCM blinks
hazard warning lamp (lock: 1 time, unlock: 2 times) and sounds Intelligent Key buzzer (lock: 1 time, unlock:
2 times) as a reminder.
OPERATION CONDITION
If the following conditions are satisfied, door lock/unlock operation is performed if the door request switch is
operated.
Key reminder
The key reminder buzzer sounds a warning if the door is locked with the key left
inside the vehicle
Warning
If an action that does not meet the operating condition of the Intelligent Key sys-
tem is taken, the buzzer sounds to inform the driver
Engine start
The engine can be turned on while carrying the Intelligent Key
Interior room lamp control
Interior room lamp is controlled according to door lock/unlock state
Function
Description
Refer
JMKIA6137GB
SYSTEM (INTELLIGENT KEY SYSTEM)
DLK-21
< SYSTEM DESCRIPTION >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
*: Even with a registered Intelligent Key remaining inside the vehicle, door locks can be unlocked from outside of the vehicle with a spare
Intelligent Key as long as key IDs are different.
Door lock function can be changed using “LOCK/UNLOCK BY I-KEY” mode in “WORK SUPPORT”. Refer to
BCS-21, "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)"
.
OUTSIDE KEY ANTENNA DETECTION AREA
The outside key antenna detection area of door lock/unlock function
is in the range of approximately 80 cm (31.50 in) surrounding the
driver, passenger door handles (1). However, this operating range
depends on the ambient conditions.
HAZARD AND BUZZER REMINDER FUNCTION
For the operation check, BCM blinks hazard warning lamps (lock: 1 time, unlock: 2 times) and sounds Intelli-
gent Key warning buzzer (lock: 1 time, unlock: 2 times) when door lock or unlock operates by operation of
each door request switch.
How to Change Hazard and Buzzer Reminder Mode
BCS-21, "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)"
.
AUTO DOOR LOCK FUNCTION
After door is unlocked by door request switch operation and if 30 seconds or more passes without performing
the following operation, all doors are automatically locked. However, operation check function does not acti-
vate.
Auto door lock mode can be changed by the “AUTO LOCK SET” mode in “WORK SUPPORT”. Refer to
21, "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)"
LIST OF OPERATION RELATED PARTS
Parts marked with
× are the parts related to operation.
Each request switch operation
Operation condition
Lock
• All doors are closed
• Ignition switch is in the LOCK or OFF position
• Intelligent Key is outside the vehicle
• Intelligent Key is within outside key antenna detection area
• P position warning is not activated
Unlock
• All doors are closed
• Ignition switch is in the LOCK or OFF position
• Intelligent Key is outside the vehicle
• Intelligent Key is within outside key antenna detection area *
JMKIA4881ZZ
Operating condition
• Door switch is ON (door is open)
• BCM receives lock signal
• Push switch is pressed
DLK-22
< SYSTEM DESCRIPTION >
SYSTEM (INTELLIGENT KEY SYSTEM)
REMOTE KEYLESS ENTRY FUNCTION
REMOTE KEYLESS ENTRY FUNCTION : System Description
INFOID:0000000009516520
SYSTEM DIAGRAM
REMOTE KEYLESS ENTRY OPERATION
The Intelligent Key has the same functions as the remote control entry system. Therefore, it can be used in the
same manner as the remote controller by operating the door lock/unlock button.
Remote keyless entry system controls operation of the following items.
• Auto door lock
• Door lock/unlock
• Hazard and buzzer reminder
OPERATION AREA
To check that the Intelligent Key works normally, use within 1 m (3 ft) range of each door, however the opera-
ble range may differ according to surroundings.
DOOR LOCK/UNLOCK FUNCTION
• When door lock/unlock button of the Intelligent Key is pressed, lock signal or unlock signal is transmitted
from Intelligent Key to BCM via remote keyless entry receiver.
• BCM receives the signal and compares it with the registered key ID to the vehicle.
• BCM transmits door lock/unlock signal to each door lock actuator and operates each door lock actuator,
when key ID matches. At the same time, BCM blinks hazard warning lamps (lock: 1 time, unlock: 2 times)
and sounds Intelligent Key buzzer (lock: 1 time, unlock: 2 times) as a reminder.
OPERATION CONDITION
Door lock function
In
te
llige
nt
Key
Re
mo
te
ke
yl
es
s en
try rec
ei
ve
r
Do
or swit
ch
Do
or requ
es
t swit
ch
Do
or loc
k ac
tu
ato
r
In
si
de
ke
y an
ten
n
a
Out
si
de ke
y a
n
ten
n
a
In
te
llige
nt
Key
wa
rnin
g
bu
zz
er
CAN co
mm
un
ic
ati
on
s
ys
tem
BC
M
Hazard w
a
rning
lamp
P
us
h-b
utt
on ig
nit
ion
s
w
itc
h
Combination meter
Door lock/unlock function
×
×
×
×
×
×
×
×
Hazard and buzzer reminder function
×
×
×
×
×
Auto door lock function
×
×
×
×
×
×
×
×
ALKIA3195GB
SYSTEM (INTELLIGENT KEY SYSTEM)
DLK-23
< SYSTEM DESCRIPTION >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
HAZARD AND BUZZER REMINDER FUNCTION
For the operation check, BCM blinks hazard warning lamps (lock: 1 time, unlock: 2 times) and sounds Intelli-
gent Key warning buzzer (lock: 1 time, unlock: 2 times) when door lock or unlock operates by each remote
controller button operation of Intelligent Key.
How to Change Hazard and Buzzer Reminder Mode
BCS-21, "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)"
.
AUTO DOOR LOCK FUNCTION
After door is unlocked by Intelligent Key button operation and if 30 seconds or more passes without performing
the following operation, all doors are automatically locked. However, operation check function does not acti-
vate.
Auto door lock mode can be changed by the “AUTO LOCK SET” mode in “WORK SUPPORT”. Refer to
21, "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)"
LIST OF OPERATION RELATED PARTS
Parts marked with
× are the parts related to operation.
KEY REMINDER FUNCTION
Remote controller operation
Operation condition
Lock
• All door are closed
• Ignition switch is in the LOCK or OFF position
• P position warning is not activated
Unlock
• Ignition switch is in the LOCK or OFF position
• Intelligent Key is outside the vehicle
• P position warning is not activated
Operating condition
• Door switch is ON (door is open)
• BCM receives lock signal
• Push switch is pressed
Remote keyless entry functions
In
te
lli
ge
nt Key
Re
mo
te
ke
yl
es
s e
nt
ry re
ce
iv
er
Doo
r swi
tch
Do
or l
oc
k
ac
tua
tor
Pu
sh
-bu
tto
n ign
iti
on
swi
tch
In
te
lli
ge
nt
Key
warn
in
g b
uz
ze
r
CAN c
om
m
un
ica
tion
sy
st
em
BCM
Co
mb
ina
tion me
ter
Hazard warning lamp
IP
DM
E/
R
Horn
Door lock/unlock function by remote control button
×
×
×
×
×
×
Hazard and buzzer reminder function
×
×
×
×
×
×
×
Auto door lock function
×
×
×
×
×
×
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст