Nissan Xterra. Instruction — part 418
EXL-160
< REMOVAL AND INSTALLATION >
FRONT FOG LAMP
FRONT FOG LAMP
Bulb Replacement
INFOID:0000000009484960
1. Remove front portion of fender protector. Refer to
EXT-22, "Removal and Installation"
2. Disconnect the harness connector from the fog lamp.
3. Turn the bulb counterclockwise and remove.
CAUTION:
• Do not touch the glass of bulb directly by hand. Keep
grease and other oily substances away from it. Do not
touch bulb by hand while it is lit or right after being turned
off. Burning may result.
• Do not leave bulb out of fog lamp reflector for a long time
because dust, moisture smoke, etc. may affect the perfor-
mance of fog lamp. When replacing bulb, be sure to
replace it with new one.
Removal and Installation
INFOID:0000000009484961
FRONT FOG LAMP
CAUTION:
• Do not leave fog lamp assembly without bulb for a long period of time. Dust, moisture, smoke, etc.
entering the fog lamp body may affect the performance. Remove the bulb from the headlamp assem-
bly just before replacement bulb is installed.
• Grasp only the plastic base when handling the bulb. Do not touch the glass envelope. Touching the
glass could significantly affect the bulb life and/or fog lamp performance.
NOTE:
The fog lamp is a semi-sealed beam type which uses a replaceable halogen bulb.
Removal
1. Remove front portion of fender protector. Refer to
EXT-22, "Removal and Installation"
2. Disconnect the harness connector from the fog lamp.
3. Remove fog lamp screws and pull fog lamp rearward out of front
bumper.
Installation
Installation is in the reverse order of removal.
LKIA0573E
LKIA0574E
LIGHTING & TURN SIGNAL SWITCH
EXL-161
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
LIGHTING & TURN SIGNAL SWITCH
Removal and Installation
INFOID:0000000009484962
REMOVAL
1. Remove instrument lower panel LH. Refer to
IP-14, "Removal and Installation"
2. Remove steering column covers. Refer to
.
3. Disconnect the harness connector from the lighting and turn sig-
nal switch.
4. While pressing tabs, pull lighting and turn signal switch toward
driver door and release from the steering column.
INSTALLATION
Installation is in the reverse order of removal.
LKIA0013E
EXL-162
< REMOVAL AND INSTALLATION >
HAZARD SWITCH
HAZARD SWITCH
Removal and Installation
INFOID:0000000009484963
REMOVAL
1. Remove cluster lid C. Refer to
IP-15, "Removal and Installation"
2. Remove the screws and the hazard switch.
INSTALLATION
Installation is in the reverse order of removal.
OPTICAL SENSOR
EXL-163
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
OPTICAL SENSOR
Removal and Installation
INFOID:0000000009484964
REMOVAL
1. Release the sensor cover (1) pawls using a suitable tool.
: Pawl
2. Disconnect the harness connector (A) from the optical sensor
(1) and remove.
INSTALLATION
Installation is in the reverse order of removal.
ALLIA1261ZZ
ALLIA1262ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст