Nissan Xterra. Instruction — part 688
OVERHAUL
TM-265
< UNIT DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
Location of Adjusting Shims, Needle Bearings, Thrust Washers and Snap Rings
INFOID:0000000009485616
2WD models
SCIA7019E
TM-266
< UNIT DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
OVERHAUL
4WD models
SCIA7020E
DISASSEMBLY
TM-267
< UNIT DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
DISASSEMBLY
Disassembly
INFOID:0000000009485617
CAUTION:
Do not disassemble parts behind Drum Support. Refer to
1. Drain A/T fluid through drain plug.
2. Remove torque converter by holding it firmly and turning while
pulling straight out.
3. Check torque converter one-way clutch using a check tool as
shown.
a. Insert a check tool into the groove of bearing support built into
one-way clutch outer race.
b. While holding bearing support with a check tool, rotate one-way
clutch spline using suitable tool.
c. Make sure that inner race rotates clockwise only. If not, replace
torque converter assembly.
4. Remove bolts and converter housing from transmission case.
CAUTION:
Do not scratch converter housing.
• Self-sealing bolt (A)
SCIA5010E
SCIA3171E
WCIA0662E
TM-268
< UNIT DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
DISASSEMBLY
5. Remove O-ring from input clutch assembly.
6. Remove oil pump assembly to transmission case bolts.
7. Remove the oil pump assembly evenly from the transmission
case using Tools.
CAUTION:
• Fully tighten the sliding hammer screws.
• Make sure that bearing race is installed to the oil pump
assembly edge surface.
8. Remove O-ring from oil pump assembly.
SCIA5011E
SCIA2300E
Tool number
: ST25850000 (J-25721-A)
SCIA5474E
SCIA5172E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст