Nissan Frontier. Instruction — part 885
HAC-94
< SYSTEM DESCRIPTION >
[MANUAL A/C (TYPE 1)]
REFRIGERATION SYSTEM
REFRIGERATION SYSTEM
Refrigerant Cycle
INFOID:0000000009478324
REFRIGERANT FLOW
The refrigerant flows in the standard pattern. Refrigerant flows through the compressor, condenser, liquid tank,
expansion valve, evaporator, and back to the compressor. The refrigerant evaporation through the evaporator
coil is controlled by an externally equalized expansion valve, located inside the evaporator case.
FREEZE PROTECTION
The compressor cycles on and off to maintain the evaporator temperature within a specified range. When the
evaporator coil temperature falls below a specified point, the intake sensor interrupts the compressor opera-
tion. When the evaporator coil temperature rises above the specification, the intake sensor allows compressor
operation.
Refrigerant System Protection
INFOID:0000000009478325
REFRIGERANT PRESSURE SENSOR
The refrigerant system is protected against excessively high- or low-pressures by the refrigerant pressure sen-
sor, located on the condenser. If the system pressure rises above or falls below the specifications, the refriger-
ant pressure sensor detects the pressure inside the refrigerant line and sends a voltage signal to the ECM.
The ECM de-energizes the A/C relay to disengage the magnetic compressor clutch when pressure on the high
pressure side detected by refrigerant pressure sensor is over about 2,746 kPa (28 kg/cm
2
, 398 psi), or below
about 120 kPa (1.22 kg/cm
2
, 17.4 psi).
PRESSURE RELIEF VALVE
The refrigerant system is also protected by a pressure relief valve, located in the rear head of the compressor.
When the pressure of refrigerant in the system increases to an abnormal level [more than 2,990 kPa (30.5 kg/
cm
2
, 433.6 psi)], the release port on the pressure relief valve automatically opens and releases refrigerant into
the atmosphere.
WJIA1482E
MANUAL AIR CONDITIONER SYSTEM
HAC-95
< SYSTEM DESCRIPTION >
[MANUAL A/C (TYPE 1)]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
MANUAL AIR CONDITIONER SYSTEM
Control System Diagram
INFOID:0000000009478326
CONTROL SYSTEM
The control system consists of input sensors, switches, the front air control (microcomputer) and outputs.
The relationship of these components is shown in the figure below:
Control System Description
INFOID:0000000009478327
CONTROL OPERATION
Front air control
AWIIA1231GB
AWIIA1229ZZ
HAC-96
< SYSTEM DESCRIPTION >
[MANUAL A/C (TYPE 1)]
MANUAL AIR CONDITIONER SYSTEM
TEMPERATURE CONTROL DIAL (TEMPERATURE CONTROL)
Increases or decreases the set temperature.
RECIRCULATION (
) SWITCH
• When REC switch is ON, REC switch indicator turns ON, and air inlet is set to REC.
• When REC switch is turned OFF, or when compressor is turned from ON to OFF, REC switch is automati-
cally turned OFF. REC mode can be re-entered by pressing REC switch again.
• REC switch is not operated when DEF switch is turned ON, or at the D/F or FOOT position.
DEFROSTER (
) SWITCH
Positions the air outlet doors to the defrost position. Also positions the intake doors to the outside air position.
REAR WINDOW DEFOGGER SWITCH (IF EQUIPPED)
When switch is ON, rear window is defogged.
OFF SWITCH (BLOWER SPEED DIAL)
The compressor and blower are OFF.
A/C SWITCH
The compressor is ON or OFF.
(Pressing the A/C switch will turn off the A/C switch and compressor.)
MODE SWITCHES
Controls the air discharge outlets.
FRONT BLOWER CONTROL DIAL
Instructionly controls the blower speed.
MAGNET CLUTCH CONTROL
When the A/C switch is pressed, or the mode switch is pressed to the DEF or D/F position, the front air control
outputs a compressor ON signal to BCM.
The BCM then sends a compressor ON signal to ECM, via CAN communication line.
ECM judges whether compressor can be turned ON, based on each sensor status (refrigerant pressure sen-
sor signal, throttle angle sensor, etc.). If it judges compressor can be turned ON, it sends compressor ON sig-
nal to IPDM E/R, via CAN communication line.
Upon receipt of compressor ON signal from ECM, IPDM E/R turns air conditioner relay ON to operate com-
pressor.
Discharge Air Flow
INFOID:0000000009478328
WJIA1293E
MANUAL AIR CONDITIONER SYSTEM
HAC-97
< SYSTEM DESCRIPTION >
[MANUAL A/C (TYPE 1)]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
Switches And Their Control Function
INFOID:0000000009478329
SWITCHES AND THEIR CONTROL FUNCTION
Mode door position
Air outlet/distribution
Vent
Foot
Defroster
95%
5%
—
60%
40%
—
20%
55%
25%
15%
50%
35%
7%
15%
78%
Airflow always present at driver and passenger side demisters
WJIA1296E
ALIIA0758GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст