Nissan Frontier. Instruction — part 1297
VTL-10
< REMOVAL AND INSTALLATION >
INTAKE SENSOR
INTAKE SENSOR
Removal and Installation
INFOID:0000000009478812
REMOVAL
1. Remove the lower dash side finisher. Refer to
.
2. Remove the assist grip handle. Refer to
.
3. Remove the front pillar upper finisher. Refer to
INT-19, "Removal and Installation"
.
4. Remove the upper glove box. Refer to
IP-23, "Removal and Installation"
5. Disconnect the harness connector from intake sensor.
NOTE:
The intake sensor is located on the top of the heater and cooling
unit assembly next to the A/C evaporator cover.
6. Twist the intake sensor to remove the intake sensor from the
heater and cooling unit assembly.
INSTALLATION
Installation is in the reverse order of removal.
WJIA1415E
BLOWER MOTOR
VTL-11
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
BLOWER MOTOR
Component
INFOID:0000000009478813
Blower Motor
Removal and Installation
INFOID:0000000009478814
REMOVAL
1. Remove the instrument lower panel RH and glove box. Refer to
IP-24, "Removal and Installation"
.
2. Disconnect the harness connector from the blower motor.
3. Remove the three screws and the blower motor.
4. Remove the blower motor wheel.
INSTALLATION
Installation is in the reverse order of removal.
AWIIA1531ZZ
1.
Heater and cooling unit assembly
2. Blower motor
3.
Variable blower control/Blower motor resistor
Front
VTL-12
< REMOVAL AND INSTALLATION >
VARIABLE BLOWER CONTROL
VARIABLE BLOWER CONTROL
Removal and Installation
INFOID:0000000009478815
Variable Blower Control
REMOVAL
1. Disconnect the harness connector from the variable blower control.
2. Remove the two screws and the variable blower control.
INSTALLATION
Installation is in the reverse order of removal.
LBIA0415E
1.
Front heater and cooling unit assembly
2.
Intake door motor
3.
Air mix door motor (driver)
4.
Variable blower control
5.
Air mix door motor (passenger)
6.
Mode door motor
BLOWER MOTOR RESISTOR
VTL-13
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
BLOWER MOTOR RESISTOR
Removal and Installation
INFOID:0000000009478816
Blower Motor Resistor
REMOVAL
1. Disconnect the harness connector from the blower motor resistor.
2. Remove the two screws and the blower motor resistor.
INSTALLATION
Installation is in the reverse order of removal.
WJIA1312E
1.
Heater and cooling unit assembly
2.
Intake door motor
3.
Air mix door motor
4.
Blower motor resistor
5.
Mode door motor
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст