Nissan Frontier. Instruction — part 1185
POWER STEERING OIL PUMP
ST-19
< REMOVAL AND INSTALLATION >
C
D
E
F
H
I
J
K
L
M
A
B
ST
N
O
P
• On VQ40DE, install the bolts to specification in the order shown.
• After installation, bleed the air from the hydraulic circuit thoroughly.
ST-6, "Air Bleeding Hydraulic System"
.
NOTE:
Belt tension is automatic and requires no adjustment.
POWER STEERING OIL PUMP BRACKET (VQ40DE)
Removal
1. Remove the power steering oil pump.
2. Remove the bolts and the power steering oil pump bracket.
Installation
1. Position the bracket and install the bracket to block bolts finger tight.
2. Tighten the bolts to specification in order as shown.
3. Install the power steering oil pump.
Power steering pump to
bracket bolt (1)
64.7 Nm (6.6 kg–m, 48 ft–lb)
Power steering pump to
block bolt (2)
28 Nm (2.9 kg–m, 21 ft–lb)
ALGIA0047ZZ
Bracket to front of block
bolt (1)
61.3 Nm (6.3 kg–m, 45 ft–lb)
Bracket to side of block
bolt (2)
61.3 Nm (6.3 kg–m, 45 ft–lb)
ALGIA0048ZZ
ST-20
< REMOVAL AND INSTALLATION >
HYDRAULIC LINE
HYDRAULIC LINE
Removal and Installation
INFOID:0000000009479925
CAUTION:
Do not reuse O-rings or copper sealing washers.
NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spill-
ing.
Refer to the following illustration for hydraulic line removal and installation.
AWGIA0195GB
1.
Reservoir tank
2.
Suction hose
3.
High pressure hose
4.
Oil cooler
5.
Steering gear assembly
6.
Reservoir tank
HYDRAULIC LINE
ST-21
< REMOVAL AND INSTALLATION >
C
D
E
F
H
I
J
K
L
M
A
B
ST
N
O
P
7.
Reservoir tank bracket
8.
Return hose
9.
Hose clamps
10. Suction hose
11. Connector bolts
12. Copper sealing washers
13. Pressure sensor
14. O-ring
A.
Reservoir tank attachment
B.
Power steering pump connec-
tions
C.
Steering gear assembly con-
nections
D.
Low pressure hose
E.
High pressure hose
Genuine Nissan PSF or
equivalent
Front
ST-22
< UNIT DISASSEMBLY AND ASSEMBLY >
STEERING COLUMN
UNIT DISASSEMBLY AND ASSEMBLY
STEERING COLUMN
Disassembly and Assembly
INFOID:0000000009479926
DISASSEMBLY
1. Remove the bolt from the upper joint, then remove the upper joint from the steering column assembly.
2. Remove the ignition switch tamper resistant self-shear screws, using a drill.
3. Remove the ignition switch from the steering column.
ASSEMBLY
Assembly is in the reverse order of disassembly.
CAUTION:
• Do not reuse the self--shear screws.
• Any time the ignition switch has been removed and installed,
the keys must be re-registered in the BCM. Refer to CONSULT
Immobilizer mode and follow the on-screen instructions.
1.
Steering column assembly
2. Upper joint
3.
Ignition switch
4.
Self-shear screw
WGIA0126E
WGIA0009E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст