Nissan Frontier. Instruction — part 1280
DISASSEMBLY
TM-331
< UNIT DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
32. Disconnect output speed sensor connector (1).
CAUTION:
Do not damage connector.
33. Straighten terminal clip (
) to free output speed sensor har-
ness.
34. Remove bolts (A), (B) and (C) from control valve with TCM.
35. Remove control valve with TCM from transmission case.
CAUTION:
When removing, be careful with the instruction valve notch and
instruction plate height. Remove it vertically.
36. Remove the A/T fluid temperature sensor 2 or plug as shown below.
a. A/T fluid temperature sensor 2
JSDIA1319ZZ
JSDIA1320ZZ
Bolt symbol
Length mm (in)
Number of bolts
A
42 (1.65)
5
B
55 (2.17)
6
C
40 (1.57)
1
SCIA5025E
SCIA5260E
TM-332
< UNIT DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
DISASSEMBLY
i.
Remove A/T fluid temperature sensor 2 with bracket from con-
trol valve with TCM.
ii.
Remove bracket from A/T fluid temperature sensor 2.
b. Plug
i.
Remove plug (1) with bracket (2) from control valve with TCM.
ii.
Remove bracket (1) from plug (2).
SCIA5253E
SCIA5264E
JSDIA1311ZZ
JSDIA1312ZZ
DISASSEMBLY
TM-333
< UNIT DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
iii. Remove O-ring (1) from plug (2).
CAUTION:
Do not reuse O-ring.
37. Remove O-ring from A/T assembly harness connector.
CAUTION:
Do not reuse O-ring.
38. Disconnect TCM connectors.
CAUTION:
Do not damage connectors.
39. Remove A/T assembly harness connector from control valve
with TCM using suitable tool.
40. Disconnect TCM connector (1) and transmission range switch
connector (2).
CAUTION:
Do not damage connectors.
JSDIA1313ZZ
SCIA5155E
SCIA5447E
SCIA5448E
JSDIA1317ZZ
TM-334
< UNIT DISASSEMBLY AND ASSEMBLY >
[5AT: RE5R05A]
DISASSEMBLY
41. Remove rear extension assembly (2WD models) or adapter case assembly (4WD models) according to
the following procedures.
a. 2WD models
i.
Remove tightening bolts for rear extension assembly and trans-
mission case.
• Bracket (1)
• Bracket (2)
• Self-sealing bolts (3)
• Bolt (A)
ii.
Tap rear extension assembly with soft hammer.
iii. Remove rear extension assembly (with needle bearing) from
transmission case.
JSDIA0293ZZ
SCIA5028E
SCIA5029E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст