Nissan Maxima. Instruction — part 956
WHEEL HUB
RAX-5
< PERIODIC MAINTENANCE >
C
E
F
G
H
I
J
K
L
M
A
B
RAX
N
O
P
PERIODIC MAINTENANCE
WHEEL HUB
On-vehicle Service
INFOID:0000000009465133
Check axle and suspension parts for excessive play, wear or damage.
• Shake each rear wheel to check for excessive play.
Inspection
INFOID:0000000009465134
Rear Wheel Bearing
• Check axial end play.
• Check that wheel hub bearings operate smoothly.
• Replace wheel bearing assembly if there is axial end play or wheel
bearing does not turn smoothly. Refer to
.
SMA525A
Axial end play : Refer to
LDIA0009E
RAX-6
< REMOVAL AND INSTALLATION >
WHEEL HUB
REMOVAL AND INSTALLATION
WHEEL HUB
Removal and Installation
INFOID:0000000009465135
REMOVAL
CAUTION:
Wheel hub assembly does not require maintenance. If any of the following symptoms are noted,
replace the wheel hub assembly.
• A growling noise is emitted from the wheel hub assembly while driving.
• The wheel hub assembly drags or turns roughly.
1. Remove the rear wheel and tire using power tool. Refer to
.
2. Remove the brake caliper assembly and brake rotor using power tool. Refer to
Installation of Brake Caliper and Rotor"
• The brake hose does not need to be disconnected from the brake caliper.
1.
Knuckle
2.
Baffle plate
3.
Wheel hub assembly
4.
Brake rotor
5.
Wheel nut
6.
Anchor block
7.
Wheel sensor
8.
Parking brake cable
.
B. Refer to
stallation - Rear Wheel Sensor"
.
C. Refer to
.
AWDIA0482GB
WHEEL HUB
RAX-7
< REMOVAL AND INSTALLATION >
C
E
F
G
H
I
J
K
L
M
A
B
RAX
N
O
P
CAUTION:
• Suspend the brake caliper assembly using wire, do not stretch the brake hose.
• Do not depress the brake pedal, or the caliper piston will pop out.
• Do not twist the brake hose.
3. Remove the rear wheel sensor, then move it away from the wheel hub assembly. Refer to
"Removal and Installation - Rear Wheel Sensor"
CAUTION:
Failure to remove the wheel sensor may result in damage to the sensor wires and the sensor
being inoperative.
4. Remove the wheel hub assembly from knuckle.
INSPECTION AFTER REMOVAL
Check for any deformity, cracks, or damage on the wheel hub assembly, replace if necessary.
INSTALLATION
Installation is in the reverse order of removal.
• Check that the wheel bearings operate smoothly.
• Check that the wheel hub bearing axial end play is within specifica-
tion.
• Tighten wheel nut to specification. Refer to
Axial end play : Refer to
.
LDIA0009E
RAX-8
< SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Wheel Bearing (Rear)
INFOID:0000000009465136
Wheel bearing axial end play
0.1 mm (0.004 in) or less
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст