Nissan Maxima. Instruction — part 279
BRM-28
< REMOVAL AND INSTALLATION >
BODY ALIGNMENT
Rear Body
INFOID:0000000009465843
Measurements
AWKIA1358GB
BODY ALIGNMENT
BRM-29
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
Roof
INFOID:0000000009465844
MEASUREMENTS (DUAL PANEL SUNROOF)
AWKIA1359GB
BRM-30
< REMOVAL AND INSTALLATION >
BODY ALIGNMENT
MEASUREMENT POINTS (DUAL PANEL SUNROOF)
AWKIA1360GB
PRECAUTIONS IN REPAIRING HIGH STRENGTH STEEL
BRM-31
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
PRECAUTIONS IN REPAIRING HIGH STRENGTH STEEL
High Strength Steel (HSS)
INFOID:0000000009465845
High strength steel is used for body panels in order to reduce vehicle weight.
Accordingly, precautions in repairing automotive bodies made of high strength steel are described below:
Read the following precautions when repairing HSS:
1. Additional points to consider
• The repair of reinforcements (such as side members) by heat-
ing is not recommended since it may weaken the component.
When heating is unavoidable, do not heat HSS parts above
550
°C (1,022°F).
Verify heating temperature with a thermometer.
(Crayon-type and other similar type thermometer are appropri-
ate.)
• When straightening body panels, use caution in pulling any
HSS panel. Because HSS is very strong, pulling may cause
deformation in adjacent portions of the body. In this case,
increase the number of measuring points, and carefully pull
the HSS panel.
Tensile strength
Major applicable parts
370 - 590 MPa
• Lower front and rear hoodledge
• Upper hoodledge
• Side dash
• Roof bow No. 2 and No.4
• 3rd crossmember
(Front floor component part)
• Inner sill
• Rear side member assembly
• Rear seat crossmember
• Center rear crossmember assembly
• Inner side roof rail
• Inner center pillar
• Inner center front bumper reinforcement
• Front bumper stay
• Rear side bumper bracket
• Other reinforcements
780 - 1350 MPa
• Front side member assembly
• Front side member closing plate assembly
• Front side member extension
• Front side member center extension
• Outer roof rail reinforcement
(Side body assembly component part)
• 2nd crossmember
(Front floor component part)
PIIA0115E
PIIA0116E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст