Nissan Maxima. Instruction — part 66
AV-84
< REMOVAL AND INSTALLATION >
[MONOCHROME DISPLAY - W/O BOSE]
AUDIO ANTENNA
4. After repair has been completed, check repaired wire for conti-
nuity. This check should be conducted 10 minutes after silver
composition is deposited.
Do not touch repaired area while test is being conducted.
5. Apply a constant stream of hot air directly to the repaired area
for approximately 20 minutes with a heat gun. A minimum dis-
tance of 3 cm (1.2 in) should be kept between repaired area and
hot air outlet.
If a heat gun is not available, let the repaired area dry for 24
hours.
SEL012D
SEL013D
AV
ANTENNA AMP.
AV-85
< REMOVAL AND INSTALLATION >
[MONOCHROME DISPLAY - W/O BOSE]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
ANTENNA AMP.
Removal and Installation
INFOID:0000000009471207
REMOVAL
1. Remove the rear pillar finisher RH. Refer to
2. Detach the antenna amp. harness clip (A).
3. Disconnect the harness connectors (B) from the antenna amp.
(1).
4. Remove the antenna amp. screw (C) and the antenna amp. (1).
INSTALLATION
Installation is in the reverse order of removal.
ALNIA0043ZZ
AV-86
< REMOVAL AND INSTALLATION >
[MONOCHROME DISPLAY - W/O BOSE]
MICROPHONE
MICROPHONE
Removal and Installation
INFOID:0000000009471208
REMOVAL
1. Remove the front room/map lamp assembly. Refer to
INL-84, "Removal and Installation"
.
2. Detach the microphone connector (A).
3. Remove the front room/map lamp covers (1), then remove the
map lamp assembly cover (2).
4. Release the microphone tabs (A), then remove the microphone
(1).
INSTALLATION
Installation is in the reverse order of removal.
ALNIA0928ZZ
ALNIA0929ZZ
ALNIA0930ZZ
AV
TEL ANTENNA
AV-87
< REMOVAL AND INSTALLATION >
[MONOCHROME DISPLAY - W/O BOSE]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
TEL ANTENNA
Removal and Installation
INFOID:0000000009471209
REMOVAL
1. Disconnect the battery negative terminal. Refer to
PG-67, "Removal and Installation (Battery)"
2. Remove the rear parcel shelf finisher. Refer to
INT-28, "Removal and Installation"
.
3. Remove the Bluetooth antenna screw (A).
4. Detach the Bluetooth antenna harness clip (B).
5. Fold down the rear seat (if equipped) or open the trunk lid, then
detach the Bluetooth antenna harness clip (C).
6. Disconnect the harness connector (D) from the Bluetooth
antenna (1) and remove.
INSTALLATION
Installation is in the reverse order of removal.
ALNIA1144ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст