Nissan Juke F15. Instruction — part 160
REPLACEMENT OPERATIONS
BRM-73
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
Roof (Standard Roof Models)
INFOID:0000000012199861
1.
Body sealing
: Vehicle front
: Welding method and the number of welding points apply to both side of the vehicle.
: Sealing portion apply to both side of the vehicle.
Replacement parts
z
Roof
z
Roof bow No. 1
z
Roof bow No. 2
z
Roof bow No. 3
JSKIA2190ZZ
BRM-74
< REMOVAL AND INSTALLATION >
REPLACEMENT OPERATIONS
Roof (Sunroof Models)
INFOID:0000000012199862
1.
Body sealing
: Vehicle front
: Welding method and the number of welding points apply to both side of the vehicle.
Replacement parts
z
Roof
z
Roof bow No. 3
JSKIA5910ZZ
BODY ALIGNMENT
BRM-75
< SERVICE DATA AND SPECIFICATIONS (SDS)
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
SERVICE DATA AND SPECIFICATIONS (SDS)
BODY ALIGNMENT
Body Center Marks
INFOID:0000000012199863
A mark is placed on each part of the body to indicate the vehicle center. When repairing the vehicle frame
(members, pillars, etc.) damaged by an accident which it enables more accurate and effective repair by using
these marks together with body alignment specifications.
Unit: mm (in)
: Vehicle front
Points
Portion
Marks
A
Front roof
Embossment
B
Cowl top
Embossment
C
Upper dash
Embossment
D
Trans control reinforcement
Hole
φ16 (0.63)
JSKIA2144ZZ
BRM-76
< SERVICE DATA AND SPECIFICATIONS (SDS)
BODY ALIGNMENT
Description
INFOID:0000000012199864
• All dimensions indicated in the figures are actual.
• When using a tracking gauge, adjust both pointers to equal length. Then check the pointers and gauge itself
to make sure there is no free play.
• When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
• Measurements should be taken at the center of the mounting holes.
• An asterisk (*) following the value at the measuring point indicates that the measuring point on the other side
is symmetrically the same value.
• The coordinates of the measurement points are the distances measured from the standard line of
″X″, ″Y″
and
″Z″.
•
″Z″: Imaginary base line [200 mm (7.87 in) below datum line (″0Z″ at design plan)]
Engine Compartment
INFOID:0000000012199865
MEASUREMENT
Dimensions marked with
″*″ indicate symmetrically identical dimensions on both the right and left hand of the
vehicle.
E
Parking brake reinforcement
Hole
φ12 (0.47)
F
Rear panel
Indent
G
Rear roof
Embossment
Points
Portion
Marks
1.
Vehicle center
2.
Front axle center
3.
Imaginary base line
JSKIA0073GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст