Nissan Juke F15. Instruction — part 879
A/C CONTROL
HAC-151
< REMOVAL AND INSTALLATION >
[MANUAL AIR CONDITIONING]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
REMOVAL AND INSTALLATION
A/C CONTROL
Exploded View
INFOID:0000000012200144
Removal and Installation
INFOID:0000000012200145
REMOVAL
1. Remove A/C finisher. Refer to
IP-13, "Removal and Installation"
.
2. Remove fixing screws (A) and fixing pawls, and then remove A/
C control.
3. Disconnect door cable and harness connector from A/C control.
INSTALLATION
Install in the reverse order of removal.
1.
Air mix door cable
2.
Intake door cable
3.
A/C control
4.
Mode door cable
5.
Intake door lever knob
A.
To air mix door link
B.
To intake door link
C.
To mode door link
JMIIA0899ZZ
: Pawl
JMIIA0900ZZ
HAC-152
< REMOVAL AND INSTALLATION >
[MANUAL AIR CONDITIONING]
THERMO CONTROL AMPLIFIER
THERMO CONTROL AMPLIFIER
Removal and Installation
INFOID:0000000012200146
REMOVAL
1. Remove evaporator. Refer to
HA-46, "EVAPORATOR : Removal and Installation"
2. Disconnect thermo control amp. from evaporator.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
• Replace O-ring with new one. Then apply compressor oil to them when installing.
• When install the thermo control amp., set the same position before replacement.
• When remove the thermo control amp., never turn the bracket which is equipped the top of the
thermo control amp.
• Check for the leakages when recharging refrigerant. Refer to
REFRIGERANT PRESSURE SENSOR
HAC-153
< REMOVAL AND INSTALLATION >
[MANUAL AIR CONDITIONING]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
REFRIGERANT PRESSURE SENSOR
Exploded View
INFOID:0000000012200147
.
Removal and Installation
INFOID:0000000012200148
REMOVAL
HA-38, "REFRIGERANT PRESSURE SENSOR : Removal and Installation"
.
INSTALLATION
Install in the reverse order of removal.
HAC-154
< REMOVAL AND INSTALLATION >
[MANUAL AIR CONDITIONING]
BLOWER FAN RESISTOR
BLOWER FAN RESISTOR
Exploded View
INFOID:0000000012200149
• *1: Instruction air conditioning
• *2: Automatic air conditioning
Removal and Installation
INFOID:0000000012200150
REMOVAL
1. Remove instrument panel assembly. Refer to
IP-13, "Removal and Installation"
.
2. Disconnect blower fan resistor harness connector.
3. Remove fixing screws, and then remove blower fan resistor from A/C unit assembly.
INSTALLATION
Install in the reverse order of removal.
1.
A/C unit assembly
2.
Blower fan resistor*
1
3.
Sub harness*
1
4.
Power transistor*
2
5.
Sub harness*
2
6.
Blower motor
JPIIA1549ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст