Nissan Juke F15. Instruction — part 1012
PARKING BRAKE SHOE
PB-5
< PERIODIC MAINTENANCE >
C
D
E
G
H
I
J
K
L
M
A
B
PB
N
O
P
PARKING BRAKE SHOE
Adjustment
INFOID:0000000012200165
1. Adjust parking brake lever stroke. Refer to
PB-4, "Inspection and Adjustment"
.
2. Perform parking brake break-in (drag on) operation by driving vehicle under the following conditions:
• Drive forward
• Vehicle speed: Approx. 43 km/h (27 MPH) set (constant and forward)
• Parking brake operating force: 125 N (12.8 kg, 28.1 lb) set contact
• Time: Approx. 8 sec.
CAUTION:
To prevent lining from getting too hot, allow a cool off period of approximately 5 minutes after
every break-in operation.
3. After the break-in procedure, check parking brake lever stroke of parking brake.
CAUTION:
If it is out of the specification, adjust again. Refer to
PB-6
< REMOVAL AND INSTALLATION >
PARKING BRAKE CONTROL
REMOVAL AND INSTALLATION
PARKING BRAKE CONTROL
Exploded View
INFOID:0000000012200166
2WD
AWD
1.
Parking brake lever assembly
2.
Adjusting nut
3.
Parking brake switch
4.
Front cable
5.
Rear cable (LH)
6.
Rear cable (RH)
: Apply multi-purpose grease.
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
: Always replace after every disassembly.
JSFIA0603GB
PARKING BRAKE CONTROL
PB-7
< REMOVAL AND INSTALLATION >
C
D
E
G
H
I
J
K
L
M
A
B
PB
N
O
P
Removal and Installation
INFOID:0000000012200167
REMOVAL
1. Remove rear tires with power tool.
2. Remove the center console assembly. Refer to
IP-24, "Removal and Installation"
3. Disconnect the parking brake switch harness connector.
4. Remove adjusting nut (1) and loosen front cable.
5. Remove the parking brake lever assembly.
1.
Parking brake lever assembly
2.
Adjusting nut
3.
Parking brake switch
4.
Front cable
5.
Rear cable (LH)
6.
Rear cable (RH)
: Apply multi-purpose grease.
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
: Always replace after every disassembly.
JSFIA0466GB
JPFIB0131ZZ
PB-8
< REMOVAL AND INSTALLATION >
PARKING BRAKE CONTROL
6. Remove rear cable with the following procedure.
a. Pull equalizer (A) of the front cable (1) in a rearward direction.
b. Push the equalizer upward to remove the rear cable (2).
7. Remove center muffler and heat plate. Refer to
8. Remove brake shoe, and remove rear cable from toggle lever.
9. Remove rear cable mounting bolts, pull out rear cable from vehi-
cle.
10. Press the pawl (1) to remove the rear cable from the vehicle.
INSTALLATION
Note the following, install in the reverse order of the removal.
• Never reuse adjusting nut.
• Perform adjustment after installation. Refer to
PB-4, "Inspection and Adjustment"
Adjustment
INFOID:0000000012200168
ADJUSTMENT AFTER INSTALLATION
Adjust the parking brake lever stroke. Refer to
PB-4, "Inspection and Adjustment"
JPFIB0129ZZ
JPFIB0130ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст