Nissan Juke F15. Instruction — part 994
OUTSIDE MIRROR
MIR-19
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
MIR
N
O
P
CAUTION:
Perform side camera image calibration (with side camera). Refer to
IMAGE (AROUND VIEW MONITOR) : Description"
GLASS MIRROR
GLASS MIRROR : Removal and Installation
INFOID:0000000012201512
REMOVAL
1. Place the glass mirror inward.
2. Apply protective tape (A) on door mirror housing and glass mir-
ror to protect it from damage.
3. Insert remover tool (A) into the recess at outside between glass mirror and door mirror actuator, and then
disengage the door mirror fixing pawls.
CAUTION:
Remove the pawls slowly so they are not damaged.
NOTE:
Insert remover tool into recesses,and push up while rotating (twisting) to make work easier.
4. Disconnect heater mirror terminals (A). (with heater mirror)
CAUTION:
Make a mark (short note, photo, etc.) of terminals layout,
before disassembly.
5. Remove glass mirror.
INSTALLATION
Note the following item, and then install in the reverse order of removal.
CAUTION:
After installation, visually check that pawls are securely engaged.
JMLIA5703ZZ
JMLIA5704ZZ
JMLIA4194ZZ
MIR-20
< REMOVAL AND INSTALLATION >
OUTSIDE MIRROR
DOOR MIRROR COVER
DOOR MIRROR COVER : Removal and Installation
INFOID:0000000012201513
REMOVAL
1. Remove the glass mirror. Refer to
MIR-19, "GLASS MIRROR : Removal and Installation"
2. Remove door mirror finisher (without around view monitor sys-
tem) or side camera finisher (with around view monitor system)
fixing screws (A), disengage door mirror cover and door mirror
finisher (without around view monitor system) or side camera
finisher (with around view monitor system) fixing pawls pushed
in the direction of the arrows as shown in figure.
3. Disengage door mirror cover fixing pawls, and then remove door
mirror cover (1) and door mirror finisher (without around view
monitor system) or side camera finisher (with around view moni-
tor system) (2).
4. Disconnect side camera harness connector. (with around view monitor system)
5. Disengage door mirror cover fixing pawls, remove door mirror
cover (1) from door mirror finisher (without around view monitor
system) or side camera finisher (with around view monitor sys-
tem) (2) indicated by arrows as shown in the figure.
INSTALLATION
Note the following item and then install in the reverse order of removal.
CAUTION:
After installation, visually check that pawls are securely engaged.
JMLIA5686ZZ
: Pawl
JMLIA5687ZZ
JMLIA5688ZZ
DOOR MIRROR REMOTE CONTROL SWITCH
MIR-21
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
MIR
N
O
P
DOOR MIRROR REMOTE CONTROL SWITCH
Exploded View
INFOID:0000000012201514
Removal and Installation
INFOID:0000000012201515
REMOVAL
1. Remove the instrument lower panel. Refer to
IP-13, "Removal and Installation"
2. Remove mounting screws and remove switch bracket from instrument lower panel.
3. Remove door mirror remote control switch (1) from switch
bracket (2) using remover tool (A).
INSTALLATION
Install in the reverse order of removal.
JMLIA1446ZZ
1.
Instrument lower panel
2.
Switch bracket
3.
Door mirror remote control switch
: Pawl
JMLIA1447ZZ
MWI
MWI-1
DRIVER INFORMATION & MULTIMEDIA
C
D
E
F
G
H
I
J
K
L
M
B
SECTION
MWI
A
O
P
CONTENTS
METER, WARNING LAMP & INDICATOR
PRECAUTION . . . . . . . . . . . ...
PRECAUTIONS . . . . . . . . . . . . ...
Precautions for Removing Battery Terminal . . .....
PREPARATION . . . . . . . . . . .
PREPARATION . . . . . . . . . . . . ...
Commercial Service Tools . . . . . . . . . ....
SYSTEM DESCRIPTION . . . . . . . ..
COMPONENT PARTS . . . . . . . . . .
METER SYSTEM . . . . . . . . . . . . . .....
METER SYSTEM : Component Parts Location . ....
METER SYSTEM : Component Description . . .....
SYSTEM . . . . . . . . . . . . . . . ..
METER SYSTEM . . . . . . . . . . . . . .....
METER SYSTEM : System Diagram . . . . . ....
METER SYSTEM : System Description . . . . ....
METER SYSTEM : Fail-Safe . . . . . . . . ..
SPEEDOMETER . . . . . . . . . . . . . .
SPEEDOMETER : System Diagram . . . . . ...
SPEEDOMETER : System Description . . . . ...
TACHOMETER . . . . . . . . . . . . . . ..
TACHOMETER : System Diagram . . . . . . .
TACHOMETER : System Description . . . . . .
SHIFT POSITION INDICATOR . . . . . . . . ..
SHIFT POSITION INDICATOR : System Diagram .
SHIFT POSITION INDICATOR : System Descrip-
tion . . . . . . . . . . . . . . . . . . ..
OIL PRESSURE WARNING LAMP . . . . . . ...
OIL PRESSURE WARNING LAMP : System Dia-
gram . . . . . . . . . . . . . . . . . .
OIL PRESSURE WARNING LAMP : System De-
scription . . . . . . . . . . . . . . . . ...
METER ILLUMINATION CONTROL . . . . . . .
METER ILLUMINATION CONTROL : System Di-
agram . . . . . . . . . . . . . . . . . ..
METER ILLUMINATION CONTROL : System De-
scription . . . . . . . . . . . . . . . . ...
METER EFFECT FUNCTION . . . . . . . . .
METER EFFECT FUNCTION : System Diagram .
METER EFFECT FUNCTION : System Descrip-
tion . . . . . . . . . . . . . . . . . . ...
INFORMATION DISPLAY . . . . . . . . . . ..
INFORMATION DISPLAY : System Diagram . . ..
INFORMATION DISPLAY : System Description . .
OPERATION . . . . . . . . . . . . . .
Switch Name and Function . . . . . . . . . ..
DIAGNOSIS SYSTEM (COMBINATION
METER) . . . . . . . . . . . . . . . .
On Board Diagnosis Function . . . . . . . . ..
CONSULT Function . . . . . . . . . . . . .
ECU DIAGNOSIS INFORMATION . . . ..
COMBINATION METER . . . . . . . . ...
Reference Value . . . . . . . . . . . . . ..
Fail-Safe . . . . . . . . . . . . . . . . ..
DTC Index . . . . . . . . . . . . . . . ...
IPDM E/R . . . . . . . . . . . . . . ...
List of ECU Reference . . . . . . . . . . . .
WIRING DIAGRAM . . . . . . . . . ..
METER SYSTEM . . . . . . . . . . . ..
Wiring Diagram . . . . . . . . . . . . . .
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст