Nissan Juke F15. Instruction — part 1224
TM-86
< UNIT REMOVAL AND INSTALLATION >
[6MT: RS6F52H]
TRANSAXLE ASSEMBLY
UNIT REMOVAL AND INSTALLATION
TRANSAXLE ASSEMBLY
Exploded View
INFOID:0000000012200818
Removal and Installation
INFOID:0000000012200819
CAUTION:
If transaxle assembly is removed from the vehicle, always replace CSC (Concentric Slave Cylinder).
Inserted CSC returns to the original position when removing transaxle assembly. Dust on clutch disc
sliding parts may damage CSC seal, and may cause clutch fluid leakage.
REMOVAL
1. Remove clutch tube from CSC. Refer to
CL-17, "Removal and Installation"
.
CAUTION:
Do not depress clutch pedal during removal procedure.
NOTE:
Cap or plug opening(s) to prevent fluid from spilling.
2. Remove engine and transaxle assembly. Refer to
EM-64, "2WD : Removal and Installation"
3. Remove starter motor. Refer to
STR-28, "MR16DDT : Removal and Installation"
4. Remove transaxle assembly to engine bolts.
5. Separate transaxle assembly from engine.
INSTALLATION
Installation is in the reverse order of removal.
1.
Transaxle assembly
2.
LH engine mount bracket
A.
TM-86, "Removal and Installation"
.
LCIA0413E
TRANSAXLE ASSEMBLY
TM-87
< UNIT REMOVAL AND INSTALLATION >
[6MT: RS6F52H]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
• If transaxle assembly is removed from the vehicle, always replace CSC. Refer to
.
• When installing the transaxle assembly to the engine, use the
specified tightening torque in the numerical sequence shown:
CAUTION:
When installing transaxle assembly, do not allow the tran-
saxle input shaft to make contact with the clutch cover.
• Bleed the air from the clutch hydraulic system. Refer to
• After installation, check oil level and check for leaks and loose mechanisms. Refer to
z
: Transaxle to engine
X
: Engine to transaxle
Bolt symbol
A
B
C
D
E
F
Quantity
1
3
1
2
2
1
Bolt length “ ”
mm (in)
45
(1.77)
80
(3.15)
45
(1.77)
35
(1.38)
45
(1.77)
Tightening torque
N·m (kg-m, ft-lb)
35.3
(3.6, 26)
74.5
(7.6, 55)
42.6
(4.3, 31)
48.0
(4.9, 35)
PCIB1972E
TM-88
< UNIT DISASSEMBLY AND ASSEMBLY >
[6MT: RS6F52H]
TRANSAXLE ASSEMBLY
UNIT DISASSEMBLY AND ASSEMBLY
TRANSAXLE ASSEMBLY
Exploded View
INFOID:0000000012200820
CASE AND HOUSING
1.
Differential side oil seal
2.
Clutch housing
3.
CSC (Concentric Slave Cylinder)
4.
Input shaft oil seal
5.
Oil channel
6.
Oil gutter A
7.
Back-up lamp switch
8.
Plunger
9.
Gasket
10. Plug
11. Bore plug
12. Striking rod oil seal
13. Transaxle case
14. Oil gutter B
15. Air breather tube
16. Park/Neutral position (PNP) switch 17. Shifter lever oil seal
18. Drain plug
19. Magnet
20. O-ring
21. Plug
: Apply Genuine Silicone RTV or an equivalent. Refer to
GI-22, "Recommended Chemical Products and Seal-
.
: Always replace after every disassembly.
: Select with proper thickness.
JSDIA5278GB
TRANSAXLE ASSEMBLY
TM-89
< UNIT DISASSEMBLY AND ASSEMBLY >
[6MT: RS6F52H]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
SHAFT AND GEAR
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
1.
Input shaft front bearing
2.
Input shaft
3.
3rd needle bearing
4.
3rd input gear
5.
3rd inner baulk ring
6.
3rd synchronizer cone
7.
3rd outer baulk ring
8.
3rd-4th spread spring
9.
3rd-4th shifting insert
10. 3rd-4th synchronizer hub
11. 4th baulk ring
12. 3rd-4th coupling sleeve
13. 4th input gear bushing
14. 4th needle bearing
15. 4th input gear
16. Thrust washer
17. 5th input gear bushing
18. 5th needle bearing
19. 5th input gear
20. 5th baulk ring
21. 5th-6th spread spring
22. 5th-6th shifting insert
23. 5th-6th synchronizer hub
24. 5th-6th coupling sleeve
25. 6th baulk ring
26. 6th input gear
27. 6th needle bearing
28. 6th input gear bushing
29. Snap ring
30. Input shaft rear bearing
31. Oil channel
32. Input shaft rear bearing adjusting
shim
33. Retaining pin
34. Reverse idler shaft
35. Thrust needle bearing
36. Reverse idler gear needle bear-
ing
37. Reverse insert spring
38. Reverse idler gear (front)
39. Reverse baulk ring
40. Reverse coupling sleeve
41. Reverse idler gear (rear)
42. Reverse idler gear adjusting shim
: Apply gear oil.
: Replace the parts as a set.
: Always replace after every disassembly.
: N·m (kg-m, ft-lb)
PCIB1888E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст