Nissan Juke F15. Instruction — part 1061
PG-104
< BASIC INSPECTION >
FUSIBLE LINK INSPECTION
FUSIBLE LINK INSPECTION
How To Check
INFOID:0000000012199815
A melted fusible link can be detected either by visual inspection or by
feeling with finger tip. If its condition is questionable, use circuit
tester or test lamp.
CAUTION:
• If fusible link should melt, it is possible that critical circuit
(power supply or large current carrying circuit) is shorted. In
such a case, carefully check and eliminate cause of malfunc-
tion.
• Never wrap outside of fusible link with vinyl tape. Important:
Never let fusible link touch any other wiring harness, vinyl or
rubber parts.
1
: Fusible link
JSMIA0352ZZ
PG
BATTERY
PG-105
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
REMOVAL AND INSTALLATION
BATTERY
Exploded View
INFOID:0000000012199816
Removal and Installation
INFOID:0000000012199817
REMOVAL
1. Disconnect the battery cable from the negative terminal. Refer to
PG-3, "Precautions for Removing Bat-
.
CAUTION:
When disconnecting, disconnect the battery cable from the negative terminal first.
2. Remove cover of battery positive terminal.
3. Disconnect the battery cable from the positive terminal. Refer to
PG-3, "Precautions for Removing Battery
4. Remove battery fix frame mounting nuts and battery fix frame.
5. Remove battery.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
To install the battery, carefully read the following instructions.
• When connecting, connect the battery cable to the positive terminal first.
• After connecting battery cables, ensure that they are tightly clamped to battery terminals for good
contact.
• Check battery terminal for poor connection caused by corrosion.
Reset electronic systems as necessary. Refer to
GI-62, "ADDITIONAL SERVICE WHEN REMOVING BAT-
TERY NEGATIVE TERMINAL : Required Procedure After Battery Disconnection"
1
: Battery fix frame
: N·m (kg-m, in-lb)
JSMIA0353GB
PG-106
< REMOVAL AND INSTALLATION >
BATTERY TERMINAL WITH FUSIBLE LINK
BATTERY TERMINAL WITH FUSIBLE LINK
Exploded View
INFOID:0000000012199818
Removal and Installation
INFOID:0000000012199819
REMOVAL
1. Disconnect the battery cable from the negative terminal. Refer to
PG-3, "Precautions for Removing Bat-
.
2. Remove cover of battery positive terminal.
3. Remove harness mounting nut and battery terminal with fusible link mounting nut.
4. Disconnect harness connector and remove battery terminal with fusible link.
INSTALLATION
Install in the reverse order of removal.
1
: Battery terminal with fusible link
2
: Harness connector
: N·m (kg-m, ft-lb)
JSMIA0354GB
PG
SERVICE DATA AND SPECIFICATIONS (SDS)
PG-107
< SERVICE DATA AND SPECIFICATIONS (SDS)
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Battery
INFOID:0000000012199820
Type
80D23L-HR
20 hour rate capacity
[V – Ah]
12 – 62
Cold cranking current (For reference value)
[A]
570
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст