Nissan Juke F15. Instruction — part 1282
TM-318
< REMOVAL AND INSTALLATION >
[CVT: RE0F10B]
CVT SHIFT SELECTOR
• The key can be removed only when the selector lever is in the “P” position. (With key interlock)
• It must not be possible to turn the ignition switch to LOCK when the selector lever is not in the “P” position.
(With key interlock)
CONTROL CABLE
TM-319
< REMOVAL AND INSTALLATION >
[CVT: RE0F10B]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
CONTROL CABLE
Exploded View
INFOID:0000000012201013
Removal and Installation
INFOID:0000000012201014
REMOVAL
CAUTION:
Always apply the parking brake before performing removal and installation.
1. Remove the battery. Refer to
PG-105, "Removal and Installation"
.
2. Remove the control cable from the CVT shift selector assembly. Refer to
TM-316, "Removal and Installa-
3. Disengage the pawls (B) of the grommet (A), and pull down-
wards to remove.
4. Remove the control cable installation nut from the instruction lever.
1.
Lock plate
2.
Bracket A
3.
Transaxle assembly
4.
Control cable
5.
Bracket B
6.
CVT shift selector assembly
A: Instruction lever
B: Grommet
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
JSDIA2353GB
JSDIA1809ZZ
TM-320
< REMOVAL AND INSTALLATION >
[CVT: RE0F10B]
CONTROL CABLE
5. Remove the lock plate (1).
6. Remove center muffler from the mounting rubber and lower the
center muffler downward. Refer to
.
7. Lift up the heat plate.
8. Remove the control cable (1) from the bracket (2).
9. Remove the control cable from the vehicle.
10. Remove bracket.
INSTALLATION
Note the following, and install in the reverse order of removal.
• From below the vehicle, press the grommet (A) into place until the
pawls (B) make a click sound.
CAUTION:
• Place the grommet on the floor, then fasten it in place from
below the vehicle.
• Check that pulling down on the grommet does not discon-
nect it.
• Pay attention to the following when connecting the control cable to the CVT shift selector.
1. When connecting the control cable (1) to the CVT shift selector
assembly (2), face the grooved surface of the rib (A) up and
insert the control cable until it stops.
JSDIA2643ZZ
:Vehicle front
JPDIA0107ZZ
JSDIA1809ZZ
JSDIA1624ZZ
CONTROL CABLE
TM-321
< REMOVAL AND INSTALLATION >
[CVT: RE0F10B]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
2. Install the socket (A) onto the CVT shift selector.
CAUTION:
• Place the socket onto the CVT shift lever, then fasten it in
place from above.
• Check that the pulling on the socket does not disconnect
it.
Inspection
INFOID:0000000012201015
INSPECTION AFTER INSTALLATION
Check the CVT position. If a malfunction is found, adjust the CVT position. Refer to
.
JSDIA1810ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст