Honda Civic Hatchback (2018 year). Manual — part 14
uu
Interior Lights/Interior Convenience Items
u
Interior Convenience Items
208
Co
ntrols
■
Front seat beverage holders
Are located in the console between the front
seats.
u
Move the armrest rearward to use the
beverage holders.
To place a short beverage container:
Move the removable beverage holder tray
forward.
To place a tall beverage container: Move
the removable beverage holder tray rearward.
■
Beverage Holders
1
NOTICE
Spilled liquids can damage the upholstery, carpeting,
and electrical components in the interior.
Be careful when you are using the beverage holders.
Hot liquid can scald you.
209
uu
Interior Lights/Interior Convenience Items
u
Interior Convenience Items
Continued
Co
ntrols
■
Rear seat beverage holders
*
Fold the armrest down to use the rear seat
beverage holders.
Are located on the rear seat.
1.5 L engine models
2.0 L engine models
* Not available on all models
210
uu
Interior Lights/Interior Convenience Items
u
Interior Convenience Items
Co
ntrols
■
Door beverage holders
Front seat
Rear seat
Continued
211
uu
Interior Lights/Interior Convenience Items
u
Interior Convenience Items
Co
ntrols
The accessory power socket can be used when the ignition switch is in ACCESSORY
(
q or ON
(
w
*1
.
Open the cover to use it.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
■
Accessory Power Socket
1
NOTICE
Do not insert an automotive type cigarette lighter
element. This can overheat the power socket.
The accessory power socket is designed to supply
power for 12-volt DC accessories that are rated 180
watts (15 amps) or less.
To prevent battery drain, only use the power socket
with the engine running.
uu
Interior Lights/Interior Convenience Items
u
Interior Convenience Items
212
Co
ntrols
To use the wireless charger, the power mode must be in ACCESSORY or ON.
Charge a compatible device on the area indicated by the
mark as follows:
1. To turn the system on and off, press and
hold the
(power) button.
u
When the system is activated, the green
indicator light comes on.
2. Place the device you want to charge on the
charging area.
u
The system will automatically start
charging the device, and the amber
indicator light will come on.
u
Make sure that the device is compatible
with the system, and placed with the
chargeable side in the center of the
charging area.
3. When charging is completed, the green
indicator light will come on.
u
Depending on the device, the amber
indicator light will stay on.
■
Wireless Charger
*
Canadian models
1
This system consumes a lot of power. Do not use the
system for a long time when the engine is not
running. This may weaken the battery, making it
difficult to start the engine.
When using the wireless charger, check the user’s
manual that came with the compatible device you
want to charge.
3
CAUTION
Metal objects between the charge pad and
the device to be charged will get hot and
can burn you.
• Always remove foreign objects from the
charge pad before charging the device.
• Be sure the surface is clear of dust and
other debris before charging.
• Do not spill liquids (i. e. water, drinks,
etc.) on the charger and the device.
• Do not use oil, grease, alcohol, benzine
or thinner for cleaning the charge pad.
• Do not cover the system with towels,
clothing, or other objects while charging
etc.
• Avoid spraying aerosols which may come
in contact with the change pad surface.
Green Indicator
Amber Indicator
Charging Area
(Power) Button
* Not available on all models
Continued
213
uu
Interior Lights/Interior Convenience Items
u
Interior Convenience Items
Co
ntrols
■
When charging does not start
Perform one of the solutions in the following table.
Indicator
Cause
Solution
Green
&
Amber
Blinking
simulta-
neously
There is an obstacle(s) between
the charging area and the
device.
Remove the
obstacle(s).
The device is not within the
charging area.
Move the device to the
center of the charging
area where
is
located.
Amber
Blinking
The wireless charger is faulty.
Contact a dealer for
repairs.
1
NOTICE
Do not place any magnetic recording media or precision
machines within the charging area while charging.
The data on your cards such as credit cards can be
lost because of the magnetic effect. Also precision
machines such as watches can go wrong.
“Qi” and
marks are the registered trademarks
owned by Wireless Power Consortium (WPC).
In the following cases, charging may stop or not start:
•
The device is already fully charged.
•
The temperature of the device is extremely high
while charging.
•
You are at a place that emits strong
electromagnetic waves or noises, such as TV
station, electric power plant, or gas station.
A device may not charge if the size or shape of its
chargeable side is not appropriate for use with the
charging area.
Not all devices are compatible with the system.
During the charging phase, it is normal for the
charging area and device to heat up.
Charging may be briefly interrupted when:
•
All the doors and the hatch are closed
- to avoid interference with the proper functioning
of the smart entry system.
•
The position of the device is altered.
Do not charge more than one device at a time on a
charging area.
* Not available on all models
uu
Interior Lights/Interior Convenience Items
u
Interior Convenience Items
214
Co
ntrols
There are coat hooks on the left and right
door pillars.
■
Coat Hooks
1
The coat hook is not designed for large or heavy
items.
Continued
215
uu
Interior Lights/Interior Convenience Items
u
Interior Convenience Items
Co
ntrols
The cargo hook in the cargo area can be used
to hang a light items.
The tie-down anchors on the cargo area floor
can be used to install a net for securing items.
■
Cargo Hook
1
NOTICE
Do not hang a large object or an object that weighs
more than 6 lbs (3 kg) on the cargo hook.
Hanging heavy or large objects may damage the
hook.
Hook
■
Tie-down Anchors
1
Do not let anyone access items in the cargo area
while driving. Loose items can cause injury if you have
to brake hard.
Anchor
Anchor
uu
Interior Lights/Interior Convenience Items
u
Interior Convenience Items
216
Co
ntrols
The cargo area cover can be used to conceal
your parcels and protect them from direct
sunlight.
■
To extend:
Pull the handle fully towards the hook on the
other side and let the hook catch hold of the
handle.
■
To retract:
Slip the rods out of the hooks, then slowly roll
it back until it is completely retracted.
■
Cargo area cover extension
The extension is attached at the back of the
hatch by four clips. It extends the covering
area when you close the hatch. To remove,
unclip the extension from the hatch. When
reinstalling the extension, make sure that the
tabs come to the near side.
■
Cargo Area Cover
1
Do not access parcels in the cargo area while driving.
This may cause injury if you have to brake hard.
Do not stack objects higher than the top of the seat
in the cargo area. They could block your view and be
thrown about the vehicle during a sudden stop.
To prevent cargo area cover damage:
•
Do not place items on the cargo area cover.
•
Do not put weight on the cargo area cover.
Handle
Hooks
Extension
Clips
Tab
Clips
217
uu
Interior Lights/Interior Convenience Items
u
Interior Convenience Items
Continued
Co
ntrols
■
To remove:
Push and hold the lever in the direction of the
arrow mark on the housing and lift the
housing out of its position.
The housing can be installed on either side of
the cargo area.
Mark
Lever
uu
Interior Lights/Interior Convenience Items
u
Interior Convenience Items
218
Co
ntrols
The ignition switch must be in ON
(
w
*1
to use
the seat heaters.
Press the seat heater button:
Once - The HI setting (three indicators on)
Twice - The MID setting (two indicators on)
Three times - The LO setting (one indicator on)
Four times - The OFF setting (no indicators on)
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
■
Front Seat Heaters
*
1
Do not use the seat heaters even in LO when the
engine is off. Under such conditions, the battery may
be weakened, making the engine difficult to start.
3
WARNING
Heat induced burns are possible when
using seat heaters.
Persons with a diminished ability to sense
temperature (e.g., persons with diabetes,
lower-limb nerve damage, or paralysis) or
with sensitive skin should not use seat
heaters.
* Not available on all models
219
uu
Interior Lights/Interior Convenience Items
u
Interior Convenience Items
Co
ntrols
The power mode must be in ON to use the
seat heaters.
There is no heater in the rear center seating
position.
While in HI, the heater cycles on and off.
u
The appropriate indicator will be on
while the seat heater is on. Briefly press
the switch on the opposite side to turn
the heater off. The indicator will be off.
■
Rear Seat Heaters
*
1
Do not use the seat heaters even in LO when the
engine is off. Under such conditions, the battery may
be weakened, making the engine difficult to start.
In the LO setting, the heater runs continuously and
does not automatically turn off.
3
WARNING
Heat induced burns are possible when
using seat heaters.
Persons with a diminished ability to sense
temperature (e.g., persons with diabetes,
lower-limb nerve damage, or paralysis) or
with sensitive skin should not use seat
heaters.
* Not available on all models
220
Co
ntrols
Climate Control System
Using Automatic Climate Control
The automatic climate control system maintains the interior temperature you select.
The system also selects the proper mix of heated or cooled air that raises or lowers
the interior temperature to your preference as quickly as possible.
Use the system when the engine is running.
1. Press the AUTO button.
2. Adjust the interior temperature using the temperature control dial.
3. Press the
(ON/OFF) button to cancel.
1
Using Automatic Climate Control
If any buttons/icons
*
are pressed while using the
climate control system in auto, the function of the
button/icon
*
that was pressed will take priority.
The AUTO indicator will go off, but functions
unrelated to the button/icon
*
that was pressed will
be controlled automatically.
To prevent cold air from blowing in from outside, the
fan may not start immediately when the AUTO
button is pressed.
If the interior is very warm, you can cool it down
more rapidly by partially opening the windows,
turning the system on auto, and setting the
temperature to low. Change the fresh air mode to
recirculation mode until the temperature cools down.
When you set the temperature to the lower or upper
limit, Lo or Hi is displayed.
Models with color audio system
AUTO Button
Temperature
Control Dial
(Recirculation) Button
(ON/OFF) Button
Fan Control
Dial
A/C (Air
Conditioning)
Button
Dashboard
vents
Dashboard
and floor
vents
Floor vents
Floor and
defroster
vents
* Not available on all models
Continued
221
uu
Climate Control System
u
Using Automatic Climate Control
Co
ntrols
Use the system when the engine is running.
1. Press the AUTO button.
2. Adjust the interior temperature using the temperature control dial.
3. Press the
(ON/OFF) button to cancel.
1
Using Automatic Climate Control
Pressing the
button switches the climate control
system between on and off. When turned on, the
system returns to your last selection.
While ECON mode is active, the climate control
system may have reduced cooling performance.
Press the
(CLIMATE) button to display
A/C, MODE, fan control information on the audio/
information screen to operate manually. Select icon
to turn on or off A/C, change the vent mode, or
change the fan speed.
Models with ECON button
Models with Display Audio
Models with Display Audio
Models without SYNC button
A/C (Air Conditioning) Icon
Fan Control Icon
Temperature
Control Dial
AUTO Button
(Recirculation) Button
(CLIMATE)
Button
Fan Control
Dial
(ON/OFF) Button
(Fresh Air) Button
MODE Control
Icon
(Floor vents)
MODE Control
Icon
(Dashboard vents)
MODE Control Icon
(Floor and
defroster vents)
MODE Control Icon
(Dashboard and
floor vents)
222
uu
Climate Control System
u
Using Automatic Climate Control
Co
ntrols
Use the system when the engine is running.
1. Press the AUTO button.
2. Adjust the interior temperature using the driver’s side or passenger’s side
temperature control dial.
3. Press the
(ON/OFF) button to cancel.
Models with Display Audio
Models with SYNC button
A/C (Air Conditioning) Icon
MODE Control
Icon
(Floor vents)
Fan Control Icon
Driver’s Side
Temperature
Control Dial
AUTO Button
(Recirculation) Button
(CLIMATE) Button
Passenger’s
Side
Temperature
Control Dial
(ON/OFF) Button
SYNC (Synchronization) Button
MODE Control
Icon
(Dashboard vents)
MODE Control Icon
(Floor and
defroster vents)
MODE Control Icon
(Dashboard and
floor vents)
223
uu
Climate Control System
u
Using Automatic Climate Control
Continued
Co
ntrols
■
Switching between the recirculation and fresh air modes
Press the
(recirculation) button and switch the mode depending on
environmental conditions.
Recirculation mode (indicator on): Recirculates air from the vehicle’s interior through
the system.
Fresh air mode (indicator off): Maintains outside ventilation. Keep the system in
fresh air mode in normal situations.
Press the
(recirculation) or
(fresh air) button to switch the mode
depending on environmental conditions.
Recirculation mode (indicator on): Recirculates air from the vehicle’s interior
through the system.
Fresh air mode (indicator on): Maintains outside ventilation. Keep the system
in fresh air mode in normal situations.
Models without fresh air button
Models with fresh air button
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст