Honda Accord Hybrid (2019 year). Manual — part 7
96
uu
Indicators
u
In
strum
e
nt Pa
nel
Indicator
Name
On/Blinking
Explanation
Message
Low Tire
Pressure/TPMS
Indicator
• May come on briefly if the power
mode is set to ON and the vehicle is
not moved within 45 seconds, to
indicate the calibration process is
not yet complete.
• Comes on and stays on when:
- One or more tires’ pressures are
determined to be significantly low.
- The system has not been
calibrated.
• Comes on while driving - Stop in a safe
place, check tire pressures, and inflate the
tire(s) if necessary.
• Stays on after the tires are inflated to
the recommended pressures - The
system needs to be calibrated.
2 TPMS Calibration P. 480
• Blinks for about one minute, and
then stays on if there is a problem
with the TPMS.
• Blinks and remains on - Have your
vehicle checked by a dealer.
• Comes on if the TPMS is
deactivated temporarily after the
12-volt battery has been
disconnected, then re-connected.
• Drive a short distance at more than 12
mph (20 km/h). The indicator should go
off. If it does not, have your vehicle
checked by a dealer.
97
uu
Indicators
u
Continued
In
strum
e
nt Pa
nel
Indicator
Name
On/Blinking
Explanation
Message
Turn Signal and
Hazard
Warning
Indicators
• Blinks when you operate the turn
signal lever.
• Blinks along with all turn signals if
you press the hazard warning
button.
• Does not blink or blinks rapidly - A
turn signal light bulb has blown. Change
the bulb immediately.
2 Replacing Light Bulbs P. 593, 594
—
High Beam
Indicator
• Comes on when the high beam
headlights are on.
—
—
Lights On
Indicator
• Comes on whenever the light
switch is on, or in AUTO when the
exterior lights are on.
• If you set the power mode to VEHICLE OFF
while the lights are on, a chime sounds
when the driver’s door is opened.
—
Fog Light
Indicator
*
• Comes on when the fog lights are
on.
—
—
* Not available on all models
98
uu
Indicators
u
In
strum
e
nt Pa
nel
*1:Canadian models only: Apply and hold the brake pedal before selecting the ON mode.
*2:Canadian models
Indicator
Name
On/Blinking
Explanation
Message
Immobilizer
System
Indicator
• Blinks if the immobilizer system
cannot recognize the key
information.
• Blinks - You cannot start the power
system. Set the power mode to VEHICLE
OFF
*1
, then select the ON mode again.
• Repeatedly blinks - The system may be
malfunctioning. Have your vehicle
checked by a dealer.
• Do not attempt to alter this system or add
other devices to it. Electrical problems can
occur.
Security System
Alarm Indicator
• Blinks when the security system
alarm has been set.
2 Security System Alarm P. 181
—
Indicator
*2
*2
Indicator
99
uu
Indicators
u
Continued
In
strum
e
nt Pa
nel
Indicator
Name
On/Blinking
Explanation
Message
System
Message
Indicator
• Comes on along with a beep when
a problem is detected. A system
message on the driver information
interface appears at the same time.
• While the indicator is on, press the
(home) button to see the message again.
2 Accessing contents in the main
• Refer to the Indicators information in this
chapter when a system message appears
on the driver information interface. Take
the appropriate action for the message.
• The driver information interface does not
return to the normal screen unless the
warning is canceled, or the left selector
wheel is pressed.
—
100
uu
Indicators
u
In
strum
e
nt Pa
nel
*1:Models without adaptive damper system
*2:Models with adaptive damper system
Indicator
Name
On/Blinking
Explanation
Message
ECON Mode
Indicator
• Comes on when you press the
ECON button.
*1
*2
101
uu
Indicators
u
Continued
In
strum
e
nt Pa
nel
*1:Models without adaptive damper system
*2:Models with adaptive damper system
Indicator
Name
On/Blinking
Explanation
Message
SPORT Mode
Indicator
• Comes on when you press the
SPORT button.
• The ambient meter remains lit up in
red as long as sport mode is on.
2 SPORT Mode P. 471
*1
*2
102
uu
Indicators
u
In
strum
e
nt Pa
nel
Indicator
Name
On/Blinking
Explanation
Message
Adaptive Cruise
Control (ACC)
with Low Speed
Follow (LSF)
Indicator
(Amber)
• Comes on if there is a problem with
ACC with LSF.
• Comes on while driving - Have your
vehicle checked by a dealer.
• Indicator comes on temporarily
when the Maximum Load Limit is
exceeded.
• ACC with LSF has been
automatically canceled.
• Make sure the total load is within the
Maximum Load Limit.
2 Maximum Load Limit P. 455
• Comes on if the ACC with LSF is
deactivated temporarily after the
12-volt battery has been
disconnected, then re-connected.
• Drive a short distance at more than 12
mph (20 km/h). The indicator should go
off. If it does not, have your vehicle
checked by a dealer.
Adaptive Cruise
Control (ACC)
with Low Speed
Follow (LSF)
Indicator
(Green)
• Comes on when you press the
MAIN button.
2 Adaptive Cruise Control (ACC) with
—
103
uu
Indicators
u
Continued
In
strum
e
nt Pa
nel
Indicator
Name
On/Blinking
Explanation
Message
Lane Keeping
Assist System
(LKAS)
Indicator
(Amber)
• Comes on if there is a problem with
the LKAS.
• Stays on constantly - Have your vehicle
checked by a dealer.
Lane Keeping
Assist System
(LKAS)
Indicator
(Green)
• Comes on when you press the
MAIN button.
2 Lane Keeping Assist System (LKAS)
P. 519
—
104
uu
Indicators
u
In
strum
e
nt Pa
nel
Indicator
Name
On/Blinking
Explanation
Message
Safety Support
Indicator
(Amber)
• Comes on if there is a problem with
RDM, CMBS
TM
, or Blind spot
information System
*
.
• Stays on constantly - Have your vehicle
checked by a dealer.
• Indicator may come on temporarily
when the Maximum Load Limit is
exceeded.
• Make sure the total load is within the
Maximum Load Limit.
• Comes on if the RDM and CMBS
TM
are deactivated temporarily after
the 12-volt battery has been
disconnected and then re-
connected.
• Drive a short distance at more than 12
mph (20 km/h). The indicator should go
off. If it does not, have your vehicle
checked by a dealer.
* Not available on all models
105
uu
Indicators
u
Continued
In
strum
e
nt Pa
nel
Indicator
Name
On/Blinking
Explanation
Message
Safety Support
Indicator
(Amber)
• Comes on when RDM and/or
CMBS
TM
shuts itself off.
• Indicator may come on temporarily when
passing through an enclosed space, such
as tunnel.
• The area around the radar sensor is
blocked by dirt, mud, etc. Stop your
vehicle in a safe place and wipe the debris
off with a soft cloth.
• Have your vehicle checked by a dealer if
the indicator does not go off even after
you have cleaned the radar sensor.
2 Collision Mitigation Braking
• Stays on - The temperature inside the
camera is too high.
Use the climate control system to cool
down the camera.
The system activates when the
temperature inside the camera cools
down.
106
uu
Indicators
u
In
strum
e
nt Pa
nel
Indicator
Name
On/Blinking
Explanation
Message
Safety Support
Indicator
(Amber)
• Comes on when RDM and/or
CMBS
TM
shuts itself off.
• Stays on - The area around the camera is
blocked by dirt, mud, etc. Stop your
vehicle in a safe place and wipe the debris
off with a soft cloth.
• Have your vehicle checked by a dealer if
the indicator and message are still
displayed even after you have cleaned the
area around the camera.
• Comes on when mud, snow, or ice
has accumulated in the vicinity of
the Blind spot information System
sensor.
• Comes on while driving - Something
may be interfering with the Blind spot
information System sensor. Check the
vicinity of the Blind spot information
System sensor and remove any obstacles.
2 Blind spot information System
P. 485
Models with Blind spot information
System
* Not available on all models
107
uu
Indicators
u
In
strum
e
nt Pa
nel
Indicator
Name
On/Blinking
Explanation
Message
Safety Support
Indicator
(Green/Gray)
• Lights up in green when RDM,
CMBS
TM
, and Blind spot
information System
*
are on.
• Lights up in green and gray when
RDM, CMBS
TM
, or Blind spot
information System
*
or any two of
these systems are off.
• Lights up in gray when RDM,
CMBS
TM
, and Blind spot
information System
*
are off.
2 Blind spot information system on
* Not available on all models
108
uu
Indicators
u
Driver Information Interface Warning and Information Messages
In
strum
e
nt Pa
nel
Driver Information Interface Warning and Information Messages
The following messages appear only on the driver information interface. Press the
(home) button, select Warnings, then press the left
selector wheel to see the message again with the system message indicator on.
Message
Condition
Explanation
• Appears when the vehicle is no longer able to run
due to a malfunction.
• Immediately stop in a safe place.
• Have your vehicle checked by a dealer immediately.
• Appears when there is a risk that the vehicle will
move unexpectedly after you have stopped due to a
malfunction with the vehicle.
• While the vehicle is stopped, apply the parking brake.
• Have your vehicle checked by a dealer.
• Appears when you set the power mode to ON again
and the vehicle is able to run.
2 Turning on the Power P. 458
109
uu
Indicators
u
Driver Information Interface Warning and Information Messages
Continued
In
strum
e
nt Pa
nel
Message
Condition
Explanation
• Appears if any door or the trunk is not completely
closed.
• Appears if any door or the trunk is opened while
driving. The beeper sounds.
• Disappears when all doors and the trunk are closed.
110
uu
Indicators
u
Driver Information Interface Warning and Information Messages
In
strum
e
nt Pa
nel
Message
Condition
Explanation
• Appears when the engine oil pressure is low.
• Appears while driving - Immediately stop in a safe
place.
2 If the Low Oil Pressure Symbol Appears P. 646
• Appears if there is a problem with the shutter grille,
and the radiator coolant temperature is too high.
• Power output will be reduced, so you may not be able
to accelerate or maintain your current speed. Have your
vehicle checked by a dealer.
• Appears when the washer fluid is low.
• Refill the washer fluid.
2 Refilling Window Washer Fluid P. 590
• Appears when the scheduled maintenance is due
soon.
• Consequently, Maintenance Due Now and
Maintenance Past Due follow.
2 Maintenance Minder Messages on the Driver
Canadian models
111
uu
Indicators
u
Driver Information Interface Warning and Information Messages
Continued
In
strum
e
nt Pa
nel
Message
Condition
Explanation
• Appears when there is a problem with the sensor on
the 12-volt battery.
• Have your vehicle checked by a dealer.
2 Checking the 12-Volt Battery P. 611
• Appears along with the 12-volt battery charging
system indicator when the 12-volt battery is not
charging.
• Turn off the climate control system and rear defogger
to reduce electricity consumption.
2 If the 12-Volt Battery Charging System Indicator
• Appears when the engine coolant temperature is
near its upper limit.
• Drive slowly to prevent overheating.
• Appears when the engine coolant temperature gets
abnormally high.
2 Overheating P. 643
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст