Lexus ES300 (1997 year). Service manual — part 209
Z19485
Horn
Horn Switch
Engine Room
Junction Block
Horn Relay
HORN Fuse
BE067–01
–
BODY ELECTRICAL
HORN SYSTEM
BE–171
1555
1997 LEXUS ES300 (RM511U)
HORN SYSTEM
LOCATION
BE068–03
N21863
N21864
N10342
BE–172
–
BODY ELECTRICAL
HORN SYSTEM
1556
1997 LEXUS ES300 (RM511U)
INSPECTION
1.
INSPECT HORN SWITCH
(a)
Disconnect the negative (–) terminal from the battery.
(b)
Remove the left and right covers from the steering wheel.
(c)
Using a torx socket wrench, loosen the 2 bolts.
(d)
Pull up the horn pad and place it on the steering column,
as shown.
HINT:
Do not disconnect the connector from the horn pad.
(e)
Disconnect the connector from the slip ring.
(f)
Check that no continuity exists between terminal 6 of the
connector and body ground.
(g)
Check that continuity exists between terminal 6 of the
connector and body ground when the horn contact plate
is pressed against the steering spoke assembly.
If continuity is not as specified, repair or replace the steering
wheel or wire harness as necessary.
(h)
Install the horn pad in place and using a torx socket
wrench, torque the 2 bolts.
Torque:
7.1 N·m (72 kgf·cm, 62 in.·lbf)
(i)
Install the left and right covers.
(j)
Connect the negative (–) terminal to the battery.
2.
INSPECT HORN OPERATION
Connect the positive (+) lead from the battery to the terminal
and negative (–) lead to the horn body and check that the horn
blows.
If operation is not as specified, replace the horn.
N14863
1
2
5
3
3
1
5
2
–
BODY ELECTRICAL
HORN SYSTEM
BE–173
1557
1997 LEXUS ES300 (RM511U)
3.
INSPECT HORN RELAY CONTINUITY
Condition
Tester connection
Specified condition
Constant
1 – 2
Continuity
Apply B+ between
terminals 1 and 2.
3 – 5
Continuity
If continuity is not as specified, replace the relay.
BO094–02
V00005
Shape (Example)
Removal/Installation
Clip Remover
Pliers
Screwdriver
Scraper
–
BODY
CLIP
BO–1
1179
1997 LEXUS ES300 (RM511U)
CLIP
REPLACEMENT
The removal and installation methods of typical clips used in body parts are shown in the table below.
HINT:
If the clip is damaged during the operation, always replace it with a new clip.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст