Lexus ES300 (1997 year). Service manual — part 426
N17520
N17520
–
DIAGNOSTICS
CRUISE CONTROL SYSTEM
DI–481
633
1997 LEXUS ES300 (RM511U)
(d)
CANCEL INSPECTION
(1)
Push the main switch ON.
(2)
Drive at a desired speed (40 km/h (25 mph) or high-
er).
(3)
When operating one of the followings, check that
the cruise control system is cancelled and that the
normal driving mode is reset.
Depress the brake pedal
Shift to except D position
Push the main switch OFF
Pull the cruise control switch to CANCEL
(e)
RESUME INSPECTION
(1)
Push the main switch ON.
(2)
Drive at a desired speed (40 km/h (25 mph) or high-
er).
(3)
When operating one of the followings, check that
the cruise control system is cancelled and that the
normal driving mode is reset.
Depress the brake pedal
Shift to except D position
Push the main switch OFF
Pull the cruise control switch to CANCEL
(4)
After the control switch is turned to RES/ACC at the
driving speed of more than 40 km/h (25 mph), check
that the vehicle restores the speed prior to the can-
cellation.
N17520
(1)
(2)
(1)
No.
Operation Method
CRUISE MAIN Indicator Light
Blinking Pattern
Diagnosis
1
Turn SET/COAST switch ON
2
Turn RES/ACC switch ON
3
Turn CANCEL switch ON
Turn stop light switch ON
Depress brake pedal
Turn PNP switch OFF
(Shift to except D position)
4
Drive at about 40 km/h
(25 mph)or higher
Drive at about 40 km/h
(25 mph) or below
Light
ON
OFF
Light
ON
OFF
Light
ON
OFF
Switch ON
Switch OFF
Light
ON
OFF
Switch OFF
Switch ON
SET/COAST switch circuit
is normal
RES/ACC switch circuit
is normal
CANCEL switch circuit
is normal
Stop light switch circuit
is normal
PNP switch circuit is
normal
Vehicle Speed Sensor is
normal
Light
ON
OFF
Light
ON
OFF
1sec.
0.25 sec.
0.25 sec.
DI–482
–
DIAGNOSTICS
CRUISE CONTROL SYSTEM
634
1997 LEXUS ES300 (RM511U)
6.
INPUT SIGNAL CHECK
HINT:
(1) For check No.1
∼
No.3
Turn ignition switch ON.
(2) For check No.4
Jack up the vehicle.
Start the engine.
Shift to D position.
(a)
Press the control switch to SET/COAST or RES/ACC
position and hold it down or hold it up ”1”.
(b)
Push the main switch ON ”2”.
(c)
Check that the CRUISE MAIN indicator light blinks twice
or 3 times repeatedly after 3 seconds.
(d)
Turn the SET/COAST or RES/ACC switch OFF.
(e)
Operate each switch as listed in the table below.
(f)
Read the blinking pattern of the CRUISE MAIN indicator
light.
(g)
After performing the check, turn the main switch OFF.
HINT:
When 2 or more signals are input to the ECU, the lowest num-
bered code will be displayed first.
DI0EJ–01
–
DIAGNOSTICS
CRUISE CONTROL SYSTEM
DI–483
635
1997 LEXUS ES300 (RM511U)
DIAGNOSTIC TROUBLE CODE CHART
If a malfunction code is displayed during the DTC check, check the circuit listed for that code in the table
below and proceed to the appropriate page.
DTC No.
(See Page)
Circuit Inspection
Trouble Area
11, 15
(
)
Actuator Motor Circuit
Actuator motor
Harness or connector between cruise control ECU and
actuator motor
Cruise control ECU
12
(
)
Actuator Magnetic Clutch Circuit
STOP Fuse
Stop light switch
Actuator magnetic clutch
Harness or connector between cruise control ECU and
actuator magnetic clutch, actuator magnetic clutch and body
ground
Cruise control ECU
14
(
)
Actuator Mechanical Malfunction
Actuator motor (actuator lock: motor, arm)
Cruise control ECU
21
(
)
Open in Vehicle Speed Sensor Circuit
Combination meter
Harness or connector between cruise control ECU and com-
bination meter, combination meter and vehicle speed sensor
Vehicle speed sensor
Cruise control ECU
23
(
)
Vehicle Speed Signal Abnormal
Vehicle speed sensor
Cruise control ECU
32
(
)
Control Switch Circuit
Cruise control switch
Harness or connector between cruise control ECU and cruise
control switch, cruise control switch and body ground
Cruise control ECU
41
Cruise control ECU
Cruise control ECU
42
Source voltage drop
Power source
51
(
)
Idle Signal Circuit
Throttle position sensor
Harness or connector between ECM and throttle position
sensor
Harness or connector between cruise control ECU and ECM
Cruise control ECU
DI0EK–01
N21505
N21506
N12490
I00642
Stop Light Switch
Cruise Control Actuator
Actuator Motor
Actuator Magnetic Clutch
Engine Room Junction Block No.2
ECU–B Fuse
Cruise Control ECU
Cruise Control switch
Main Switch
Control Switch
DLC2
Instrument Panel Junction Block No.1
ECU–IG Fuse
STOP Fuse
Vehicle Speed Sensor
Park/Neutral Position Switch
CRUISE MAIN Indicator Light
DI–484
–
DIAGNOSTICS
CRUISE CONTROL SYSTEM
636
1997 LEXUS ES300 (RM511U)
PARTS LOCATION
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст