Lexus ES300 (1997 year). Service manual — part 155
N21529
–
BODY
SLIDING ROOF
BO–73
1251
1997 LEXUS ES300 (RM511U)
5.
REMOVE SLIDING ROOF HOUSING
(a)
Disconnect the 4 drain hoses from the housing.
(b)
Remove the 8 bolts and 4 brackets.
(c)
Remove the 6 nuts, then remove the housing as shown
in the illustration below.
BO0AN–01
N21523
N21421
N21424
N21526
N21525
BO–74
–
BODY
SLIDING ROOF
1252
1997 LEXUS ES300 (RM511U)
DISASSEMBLY
1.
REMOVE SLIDING ROOF PANEL STOPPER
Remove the 2 screws and 2 stoppers.
2.
REMOVE SUNSHADE TRIM
3.
REMOVE REAR ROOF DRIP CHANNEL
Remove the rear roof drip channel as shown in the illustration.
4.
REMOVE REAR FRAME
Remove the 4 screws and rear frame.
5.
REMOVE DRIVE CABLE
(a)
Remove the screw and guide rail stopper.
(b)
Slide the drive cable rearward, then remove it.
HINT:
At the time of assembly, please refer to the following items.
Adjust the drive cable to a closed and tilted down position.
Slide the cable forward or backward to align the 2 marks
as shown.
Slide the cable to the forefront with your hand.
6.
REMOVE ROOF WINDOW DEFLECTOR PANEL
N21423
N21420
N21522
–
BODY
SLIDING ROOF
BO–75
1253
1997 LEXUS ES300 (RM511U)
7.
REMOVE FRONT HOUSING PLATE
Remove the 2 screws and plate.
8.
REMOVE GUIDE BLOCK
Remove the 2 screws and guide block.
9.
REMOVE SLIDING ROOF HOUSING
Remove the 6 screws and sliding roof housing.
BO0AO–01
N21422
Z04207
BO3396
N21525
BO–76
–
BODY
SLIDING ROOF
1254
1997 LEXUS ES300 (RM511U)
ADJUSTMENT
1.
REMOVE SIDE GARNISH
Before making adjustments, using a screwdriver, remove the
side garnishes.
HINT:
Tape the screwdriver tip before use.
After adjustment, reinstall the side garnishes.
2.
ADJUST SLIDING ROOF GLASS FORWARD OR
REARWARD
(a)
Using a torx wrench, loosening the sliding roof glass
installation screws.
(b)
Adjust the sliding roof glass forward or rearward.
3.
ADJUST SLIDING ROOF GLASS IN CLEARANCE
(Difference in left and right clearance)
(a)
When the front or rear alignment is not correct, remove
the drive gear and sliding roof glass, then adjust the drive
cable.
NOTICE:
Remove the drive gear with the sliding roof full closed.
(b)
Adjust by sliding the cable forward or rearward to align the
2 marks as shown.
(c)
Install the drive gear and sliding roof glass.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст