Lexus SC300 / Lexus SC400. Service manual — part 124
SERVICE SPECIFICATIONS
TORQUE SPECIFICATIONS
Part tightened
N
⋅
m
kgf
⋅
cm
ft
⋅
lbf
HOOD
Hood support X Hood
22
225
16
Hood support X Body
22
225
16
TRANSPORT HOOK
Front Transport Hook
Front transport hook X Body
64
650
47
Rear Transport Hook
Rear transport hook X Body
64
650
47
SEAT
Front seat
Power seat regulator X Body
37
375
27
Seat back assembly X Seat cushion assembly
26
260
19
Power seat regulator X Seat cushion assembly
26
260
19
Rear seat
Rear seat back X Body
18
185
13
SEAT BELT
Front Seat Belt
Front seat outer belt anchor X Body
43
440
32
Front seat outer belt lower side X Body
43
440
32
ELR X Body
43
440
32
Front seat inner belt X Power seat regulator
43
440
32
Rear Seat Belt
Rear seat outer belt anchor X Body
43
440
32
ELR X Body
43
440
32
Rear seat inner belt X Body
43
440
32
BUMPER
Front Bumper
Front bumper reinforcement X Body
13
130
9.4
Rear Bumper
Rear bumper reinforcement X Body
13
130
9.4
BO–138
–
BODY
Service Specifications
Specifications
(Fitting Adjustments)
–
BODY
Service Specifications
BO–139
BODY
BO–1
Example
GENERAL INFORMATION
HANDLING PRECAUTIONS
Taping
When it is possible that the body or parts may be scratched
during the operation, apply protection tape before starting
work.
Example:
1. Before starting work, apply protection tape to body
surfaces around parts to be removed and installed.
2.
Before prying parts loose with a screwdriver or scraper
etc., apply protection tape to the tip of the tool to avoid
scratching parts or painted surfaces of the body.
Battery
In order to prevent a short circuit while doing work on the elec-
trical circuit such as disconnecting a connector, first turn off
the ignition switch and disconnect the negative cable from
the battery terminal before starting work.
HINT:
When battery voltage is required for operation of a
functioning part, connect the cable to the battery when need-
ed, and promptly disconnect it when no longer necessary.
CAUTION:
•
Work must be started after approx. 20 seconds or longer
from the time the ignition switch is turned to the ”LOCK”
position and the negative (–) terminal cable is
disconnected from the battery.
•
To avoid erasing the memory of each memory system,
never use a back–up power supply from outside the
vehicle.
Fitting Adjustments
When removing and installing body panels which have a pre-
load value, after the installation refer to the page containing
the installation adjustment methods, and make adjustments
according to the required specifications.
HINT:
When making adjustments, do not completely loos-
en the bolts and nuts of the part being adjusted. Tighten them
appropriately, and move the panels by hand to align them.
BO–2
–
BODY
General Information
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст