Lexus SC300 / Lexus SC400. Service manual — part 810
PREPARATION
SST (SPECIAL SERVICE TOOLS)
SA0A5–02
RECOMMENDED TOOLS
SA06X–03
EQUIPMENT
SA0A7–01
ÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑ
ÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑ
ÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑ
Torque wrench
ÑÑÑÑÑÑÑÑÑÑ
ÑÑÑÑÑÑÑÑÑÑ
ÑÑÑÑÑÑÑÑÑÑ
SA–106
–
SUSPENSION AND AXLE
REAR SUSPENSION
REAR SHOCK ABSORBER
COMPONENTS
SA0SB–05
–
SUSPENSION AND AXLE
REAR SUSPENSION
SA–107
REAR SHOCK ABSORBER REMOVAL
SA0SC–02
1.
JACK UP VEHICLE AND REMOVE REAR WHEEL
2.
REMOVE REAR BRAKE CALIPER
(a) Remove the 2 bolts and remove the brake caliper from the
rear axle carrier.
(b) Hang up the brake caliper using wire, etc.
3.
REMOVE SHOCK ABSORBER WITH COIL SPRING
(a) Remove
the nut and bolt on lower side of the shock absorber.
(b) Remove the absorber cap.
(c) Loosen the nut in the middle of the suspension support.
NOTICE: Only loosen the nut, do not remove it.
(d) Remove the 3 nuts and shock absorber with the coil spring.
SA–108
–
SUSPENSION AND AXLE
REAR SUSPENSION
4.
REMOVE SUSPENSION SUPPORT AND COIL SPRING
(a) Install a bolt and 2 nuts to the bracket at the lower portion of
the shock absorber shell and secure it in a vise.
(b) Using SST, compress the coil spring.
SST 09727–30020
NOTICE: Do not use an impact wrench.
It will damage the SST.
(c) Remove the suspension support nut.
(d) Remove the suspension support, coil spring and insulator.
(e) Remove the insulator and spring bumper from the
suspension support.
–
SUSPENSION AND AXLE
REAR SUSPENSION
SA–109
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст