Lexus LS400 (2000 year). Service manual — part 57
BE0BK–01
Z14984
BE–56
–
BODY ELECTRICAL
FOG LIGHT SYSTEM
1919
INSPECTION
1.
INSPECT FOG LIGHT RELAY CONTINUITY
Condition
Tester connection
Specified condition
Constant
1 – 2
Continuity
Apply B+ between
terminals 1 and 2.
3 – 4
Continuity
If continuity is not as specified, replace the relay.
2.
INSPECT FOG LIGHT RELAY CIRCUIT
(See page
BE0BL–01
I03240
–
BODY ELECTRICAL
FOG LIGHT SYSTEM
BE–57
1920
ADJUSTMENT
ADJUST FOG LIGHT AIM
A–bolt: Vertical Direction
BE0BM–01
I03230
Engine Room Junction Block
HAZ Fuse
Hazard Warning Switch
Front Turn
Signal Light
Instrument Panel Junction Block
TURN Fuse
Combination Switch
Turn Signal Switch
Light Control Switch
Rear Combination Light
Rear Turn Signal Light
Turn Signal Flasher
BE–58
–
BODY ELECTRICAL
TURN SIGNAL AND HAZARD WARNING SYSTEM
1921
TURN SIGNAL AND HAZARD WARNING SYSTEM
LOCATION
BE0BN–01
I03480
Wire Harness Side
Z08888
ON
–
BODY ELECTRICAL
TURN SIGNAL AND HAZARD WARNING SYSTEM
BE–59
1922
INSPECTION
1.
INSPECT TURN SIGNAL FLASHER CIRCUIT
Disconnect the connector from the combination switch and in-
spect the connect on the wire harness side, as shown.
Tester connection
Condition
Specified condition
2 – Ground
Constant
Continuity
3 – Ground
Constant
Continuity
5 – Ground
Turn signal switch RIGHT or OFF
No continuity
5 – Ground
Turn signal switch LEFT
Continuity
6 – Ground
Turn signal switch LEFT
No continuity
6 – Ground
Turn signal switch RIGHT
Continuity
7 – Ground
Constant
Continuity
8 – Ground
Hazard warning switch OFF
No continuity
8 – Ground
Hazard warning switch ON
Continuity
1 – Ground
Ignition switch LOCK or ACC
No voltage
1 – Ground
Ignition switch ON
Battery positive voltage
4 – Ground
Constant
Battery positive voltage
If circuit is as specified, replace the relay.
If circuit is not as specified, inspect the circuits connected to oth-
er parts.
2.
INSPECT HAZARD WARNING SWITCH CONTINUITY
Switch position
Tester connection
Specified condition
OFF
7 – 10
Continuity
ON
7 – 8
Continuity
Illumination circuit
2 – 3
Continuity
If continuity is not as specified, replace the switch.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст