Lexus LS400 (2000 year). Service manual — part 42
I03487
GARAGE DOOR
OPENER SWITCH
LEARN MODE
LED
OPERATION
ORIGINAL
TRANSMITTER
PRESSED
ENTER
EXIT
ON
OFF
20 sec
LED flashes
at a rate of 1 Hz
LED flashes at a
rate of 5.6 Hz
RELEASE
ON
OFF
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
BE–237
2100
New code registration timing chart
If a code can not be registered, observe the following condi-
tions.
HINT:
If the battery of original transmitter is consumed.
Press the switch of the transmitter repeatedly in registra-
tion mode, as some transmitters stop transmitting for 1 to
2 seconds.
This system is not applicable to the garage door opener
which had been made before 1982.
2.
CODE DELETION
(a)
Press the switches at both ends of garage door opener
simultaneously for 20 seconds.
HINT:
When transferring to deletion mode, LED (red) blinks in 6 Hz
cycle.
(b)
When releasing the switch within 10 seconds after trans-
ferring to deletion mode, all the registered codes will be
erased.
HINT:
Press the switch until blinking in 6 Hz cycle stops, so that the
default code for check is set.
I03488
LED
OPERATION
GARAGE DOOR
OPENER SWITCH
(Switch at both end)
ON
OFF
CLEAR/DEFAULT
MODE
PRESSED
LOAD DEFAULT
LED flashes at a rate of 6 HZ
10 SEC
20 SEC
RELEASE
ON
OFF
Enter erase mode to erase all 3 channels
BE–238
–
BODY ELECTRICAL
GARAGE DOOR OPENER SYSTEM
2101
Code deletion timing chart
BE0D3–01
I03403
Garage Door Opener
–
BE–239
2102
LOCATION
BE0D4–01
I03419
BE–240
–
2103
REMOVAL
1.
REMOVE FRONT PERSONAL LIGHT LENS
2.
REMOVE FRONT PERSONAL LIGHT
(a)
Remove the 3 screws.
(b)
Disconnect the 2 connectors.
3.
REMOVE GARAGE DOOR OPENER
(a)
Remove the 3 screws.
(b)
Remove the garage door opener connector from the per-
sonal light.
(c)
Disconnect the secondary locking device.
(d)
Release the locking plug of the terminal 4 and 5, and pull
the terminals out from the rear.
HINT:
Use a small screw driver.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст