Lexus LS400 (2000 year). Service manual — part 96
P21961
EM–72
–
ENGINE MECHANICAL
CYLINDER HEAD
1254
27.
CONNECT FRONT EXHAUST PIPE TO TWC
(a)
Temporarily install the pipe support bracket to the trans-
mission with the 2 bolts.
(b)
Install a new gasket to each rear end of the TWC.
(c)
Connect the front exhaust pipe to the 2 front TWC and
pipe support bracket with the 4 bolts and 4 new nuts.
Torque: 43.1 N·m (440 kgf·cm, 32 ft·lbf)
(d)
Tighten the 2 bolts holding the pipe support bracket to the
transmission.
Torque: 43.1 N·m (440 kgf·cm, 32 ft·lbf)
28.
INSTALL PS PUMP (See page
)
29.
INSTALL CAMSHAFT POSITION SENSOR
(See page
)
30.
INSTALL CAMSHAFT TIMING PULLEYS
(See page
)
31.
CONNECT TIMING BELT TO CAMSHAFT TIMING PUL-
LEYS (See page
)
32.
CHECK ENGINE OIL LEVEL
EM09W–02
A02231
Hood
Air Cleaner and
Intake Air Connector
Assembly
V–Bank Cover
Air Cleaner Inlet
Battery Clamp
Cover
Battery Hold–Down
Clamp
MAF Meter
Connector
PS Air
Hose
Positive Cable
from Engine
Wire
Accelerator Cable
Upper Radiator Support
Radiator Assembly
Lower Radiator Support
Fan and Fluid Coupling
Assembly
Engine Mount Member
Bracket Plate
ECT Switch Connector
for A/C Cooling Fan
Battery
Battery
Insulator
Lower Front Suspension
Member Protector
Engine Under Cover
Generator
Drive Belt
x 8
x 7
Oil Pun Protector
x 11
EVAP Hose
PCV Hose
–
ENGINE MECHANICAL
ENGINE UNIT
EM–73
1255
ENGINE UNIT
COMPONENTS
A02234
Grove Compartment
ECM Connector
Cowl Wire
Connector
Under Cover
Engine Wire Grommet
Heater Hose
Brake Booster Vacuum Hose
Fuel Inlet Hose
Ground
Strap
Oil Pressure Switch
Connector
Wire Bracket
Generator Wire
Generator
Connector
Engine Oil
Level Sensor
Connector
Ground
Strap
EM–74
–
ENGINE MECHANICAL
ENGINE UNIT
1256
A02235
Engine and Transmission Assembly
Rear Engine Mounting
Member
ABS Actuator
Gasket
Wire Bracket
A/C Compressor
Connector
Rear Center Floor
Crossmember Brace
Adjusting Washer
Propeller Shaft
Front Center Floor
Crossmember Brace
Heat Insulator
for Rear Side of
Front Exhaust Pipe
RH Heat Insulator for
Front Side of Front Exhaust Pipe
Front Exhaust Pipe
Heated Oxygen Sensor
(Bank 1 Sensor 2)
Center Exhaust Pipe
Pipe
Support
Bracket
PS Pump
Wire Clamp
A/C Compressor Stay
Adjusting Washer
Gasket
Gasket
Gasket
LH Heat Insulator for
Front Side of Front
Exhaust Pipe
Gasket
Gasket
Non–reusable part
Ground Cable
61.8 (630, 46)
61.8 (630, 46)
43.1 (440, 32)
43.1 (440, 32)
13.5 (135, 10)
25 (250, 19)
Heated Oxygen Sensor
(Bank 2 Sensor 2)
N·m (kgf·cm, ft·lbf) : Specified Torque
–
ENGINE MECHANICAL
ENGINE UNIT
EM–75
1257
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст