Lexus GS300/400 (2000 year). Service manual — part 259
SA0RD–01
W00593
SST
SA–20
–
SUSPENSION AND AXLE
FRONT SHOCK ABSORBER
2020
DISASSEMBLY
REMOVE SUSPENSION SUPPORT AND COIL SPRING
(a)
Using SST, compress the coil spring.
SST
09727–30021
NOTICE:
Do not use an impact wrench. It will damage the SST.
(b)
Remove the piston rod lock nut.
(c)
Remove these parts from the shock absorber:
Suspension support No.2
Spring bumper
Coil spring
SA0RE–01
W00277
–
SUSPENSION AND AXLE
FRONT SHOCK ABSORBER
SA–21
2021
INSPECTION
INSPECT SHOCK ABSORBER
Compress and extend the shock absorber rod and check that
there is no abnormal resistance or unusual operation sounds.
If there is any abnormality, replace the shock absorber with a
new one.
NOTICE:
When discarding the shock absorber, see DISPOSAL on
page
.
SA0RF–01
F03480
SA–22
–
SUSPENSION AND AXLE
FRONT SHOCK ABSORBER
2022
DISPOSAL
1.
FULLY EXTEND SHOCK ABSORBER ROD
2.
DRILL HOLE TO REMOVE GAS FROM CYLINDER
(a)
Place the shock absorber horizontally to prevent the oil
from coming out.
(b)
Using a drill, make a hole on the top of the shell as shown
to discharge the gas inside.
CAUTION:
The gas coming out is harmless, but be careful of chips
which may fly up when drilling.
SA0RG–01
W00278
W00276
SST
W00288
Outside
Rear
20
°
Suspension Support
Shock Absorber
Lower Bushing
–
SUSPENSION AND AXLE
FRONT SHOCK ABSORBER
SA–23
2023
REASSEMBLY
1.
INSTALL SPRING BUMPER TO SUSPENSION
SUPPORT
HINT:
Match the bolt of the suspension support with the cut–out part
of the spring bumper.
2.
INSTALL COIL SPRING TO SHOCK ABSORBER
(a)
Using SST, compress the coil spring.
SST
09727–30021
NOTICE:
Do not use an impact wrench. It will damage the SST.
(b)
Install the coil spring to the shock absorber.
HINT:
Fit the lower end of the coil spring into the recess of the spring
seat of the shock absorber.
3.
INSTALL SUSPENSION SUPPORT
(a)
Install the suspension support to the rod.
(b)
Temporarily tighten a new lock nut.
(c)
Align the suspension support with the shock absorber
lower bolt, as shown.
4.
REMOVE SST
HINT:
After removing the SST, recheck the direction of the suspension
support.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст