Lexus GS300/400 (2000 year). Service manual — part 251
RS07V–01
H02694
H02695
H02696
RS–58
–
SUPPLEMENTAL RESTRAINT SYSTEM
FRONT AIRBAG SENSOR
2289
REMOVAL
NOTICE:
If the wiring connector of the SRS is disconnected
with the ignition switch in ON or ACC position, DTCs
will be recorded.
Never use SRS parts from another vehicle. When re-
placing parts, replace them with new parts.
Never reuse the sensor involved in a collision when
the SRS has deployed.
Never repair a sensor in order to reuse it.
1.
REMOVE LH FRONT AIRBAG SENSOR
(a)
Remove the 2 bolts and J/B cover.
(b)
Remove the bolt and 2 nuts.
(c)
Disconnect the connectors and hose, then remove the
J/B box.
(d)
Disconnect the connector, then remove the bolt, nut and
sensor.
H02698
H02702
H02699
H02697
–
SUPPLEMENTAL RESTRAINT SYSTEM
FRONT AIRBAG SENSOR
RS–59
2290
2.
REMOVE RH FRONT AIRBAG SENSOR
(a)
Remove the bolt and No.1 air cleaner inlet.
(b)
2JZ–GE Engine:
Disconnect the connector and inlet hose, then remove the
3 bolts and air cleaner.
(c)
1UZ–FE Engine:
Disconnect the connector and inlet hose, then remove the
3 bolts and air cleaner.
(d)
Disconnect the connector, then remove the bolt, nut and
sensor.
RS07W–01
H02700
H02701
LH
RH
RS–60
–
SUPPLEMENTAL RESTRAINT SYSTEM
FRONT AIRBAG SENSOR
2291
INSPECTION
1.
VEHICLES NOT INVOLVED IN COLLISION
Do a diagnostic system check. (See page
2.
VEHICLES INVOLVED IN COLLISION
(a)
Do a diagnostic system check. (See page
(b)
If the front fender of the car or its periphery is damaged,
do a visual check for damage to the front airbag sensor,
which includes the following items even if the airbag was
not deployed:
Bracket deformation
Paint peeling off the bracket
Cracks, dents or chips in the case
Cracks, dents, chipping and scratches in the con-
nector
Peeling of the label or damage to the serial number
RS07X–01
–
SUPPLEMENTAL RESTRAINT SYSTEM
FRONT AIRBAG SENSOR
RS–61
2292
REPLACEMENT
REPLACEMENT REQUIREMENTS
In the following cases, replace the front airbag sensor.
If the SRS has been deployed in a collision. (Replace both the left and right airbag sensors.)
If the front airbag sensor has been found to be faulty in troubleshooting.
If the front airbag sensor has been found to be faulty during the check in item.
(See page
)
If the front airbag sensor has been dropped.
CAUTION:
For removal and installation of the front airbag sensor, see page
Be sure to follow the correct procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст