Lexus RX300 (MCU15). Service manual — part 147
I07323
LH
Side
RH
Side
4
5
I07324
LH
Side
RH
Side
5
6
I07325
LH
Side
RH
Side
5
6
–
BODY ELECTRICAL
POWER MIRROR CONTROL SYSTEM
BE–135
LEXUS RX300 (RM785E)
(b)
Reverse the polarity, check that the mirror turns to right
side.
(c)
Connect the positive (+) lead from the battery to terminal
5 and the negative (–) lead to terminal 6, check that the
mirror turns upward.
(d)
Reverse the polarity, check that the mirror turns down
ward.
If operation is not as specified, replace the mirror assembly.
BE0HC–08
I19139
Ignition Switch
Instrument Panel J/B
D ECU–IG
Electro Chromic Outer
Mirror
Electro Chromic Inner Mirror
BE–136
–
BODY ELECTRICAL
ELECTRO CHROMIC MIRROR SYSTEM
LEXUS RX300 (RM785E)
ELECTRO CHROMIC MIRROR SYSTEM
LOCATION
BE0UN–02
I05186
”Bright”
”Dark”
1
2
3
4
Black coloured tape
I04048
Wire Harnes Side
–
BODY ELECTRICAL
ELECTRO CHROMIC MIRROR SYSTEM
BE–137
LEXUS RX300 (RM785E)
INSPECTION
1.
INSPECT ELECTRO CHROMIC INNER MIRROR OP-
ERATION
(a)
Connect the positive (+) lead from the battery to terminal
1 and the negative (–) lead to terminal 4.
(b)
Connect the positive (+) lead from the voltmeter to termi-
nal 2 and the negative (–) lead to terminal 3.
(c)
Attach a black coloured tape to forward sensor to prevent
it from sensing.
(d)
When the mode is turned to AUTO, check that indicator
light lights up.
(e)
Light up the mirror with an electric light, and check that
there is battery positive voltage and mirror surface
changes ”bright” to ”dark”.
If operation is not as specified, replace the inner mirror.
2.
INSPECT ELECTRO CHROMIC INNER MIRROR CIR-
CUIT
Disconnect the connector from the mirror and inspect the con-
nector on the wire harness side, as shown.
Tester connection
Condition
Specified condition
4 – Ground
Constant
Continuity
1 – Ground
Ignition switch LOCK or ACC
No voltage
1 – Ground
Ignition switch ON
Battery positive voltage
If circuit is not as specified, inspect the circuits connected to
other parts.
I07326
”Bright”
”Dark”
2
1
BE–138
–
BODY ELECTRICAL
ELECTRO CHROMIC MIRROR SYSTEM
LEXUS RX300 (RM785E)
3.
INSPECT ELECTRO CHROMIC OUTER MIRROR OP-
ERATION
(a)
Disconnect the outer mirror connector.
(b)
Connect the positive (+) lead from the dry cell battery to
terminal 2 and the negative (–) lead to terminal 1, then
check that the mirror surface changes to ”dark”.
(c)
Check the mirror turns to ”bright” after disconnecting the
battery.
If operation is not as specified, replace the mirror assembly.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст