Chrysler Voyager. Manual — part 327
Symptom:
BUS MESSAGES MISSING
When Monitored and Set Condition:
BUS MESSAGES MISSING
When Monitored:
While the EVIC is performing a series of tests on the microprocessor,
compass coil, and internal circuitry.
Set Condition:
The code will be set, if during the self test the EVIC does not receive
messages from the BCM, FCM, EATX or PCM.
POSSIBLE CAUSES
BCM COMMUNICATION
PCM COMMUNICATION
FCM COMMUNICATION
EATX COMMUNICATION
EVIC
TEST
ACTION
APPLICABILITY
1
Turn the ignition on.
With the DRBIII
t, attempt to communicate with BCM.
Can communication be established with the BCM?
All
Yes
→ Go To 2
No
→ Refer to Communication Category and perform the appropriate
system.
Perform BODY VERIFICATION TEST - VER 1.
2
Turn the ignition on.
With the DRBIII
t, access Body Control Module.
Select Body Controller and System test.
Does the DRBIII
t display PCM Active on the Bus?
All
Yes
→ Go To 3
No
→ Refer to Communication Category and perform the appropriate
system.
Perform BODY VERIFICATION TEST - VER 1.
3
Turn the ignition on.
With the DRBIII
t, attempt to communicate with the FCM.
Can communication be established with the FCM?
All
Yes
→ Go To 4
No
→ Refer to Communication Category and perform the appropriate
system.
Perform BODY VERIFICATION TEST - VER 1.
735
OVERHEAD CONSOLE
TEST
ACTION
APPLICABILITY
4
Turn the ignition on.
With the DRBIII
t, attempt to communicate with the EATX.
Can communication be established with the EATX?
All
Yes
→ Replace the EVIC Module.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Refer to Communication Category and perform the appropriate
system.
Perform BODY VERIFICATION TEST - VER 1.
736
OVERHEAD CONSOLE
BUS MESSAGES MISSING —
Continued
Symptom:
COMPASS TEST FAILURE
When Monitored and Set Condition:
COMPASS TEST FAILURE
When Monitored:
During the EVIC self test.
Set Condition:
POSSIBLE CAUSES
CMTC/EVIC MODULE
TEST
ACTION
APPLICABILITY
1
Perform the CMTC/EVIC self test.
Turn the ignition off.
Depress and hold the RESET and STEP buttons while turning the ignition on.
NOTE: This test may also be performed using the DRBIII
t.
Does the CMTC/EVIC or DRBIII
t display 9FAILED SELF TEST9?
All
Yes
→ Replace the CMTC or EVIC in accordance with the Service
Information.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Test Complete.
737
OVERHEAD CONSOLE
Symptom:
DEMAGNETIZE COMPASS AS PER SERVICE MANUAL
When Monitored and Set Condition:
DEMAGNETIZE COMPASS AS PER SERVICE MANUAL
When Monitored:
During the EVIC self test.
Set Condition:
Compass has been magnetized.
POSSIBLE CAUSES
DEMAGNETIZE COMPASS
TEST
ACTION
APPLICABILITY
1
Refer to the Service Information for the Demagnetizing Procedure.
View Repair for Verification Test.
All
Repair
When the Demagnetizing Procedure is complete perform the
Verification Test.
Perform BODY VERIFICATION TEST - VER 1.
738
OVERHEAD CONSOLE
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст