Dodge Stratus Coupe (2005 year). Instruction — part 19
4. There is a fuse puller in the cover of the instrument
panel (driver’s side). Remove the fuse puller, clamp it on
the fuse you wish to remove, and pull the fuse straight
out from the fuse block. If the fuse is not blown, some-
thing else must be causing the problem; contact an
authorized dealer to have the problem checked.
5. Insert a new fuse of the same capacity securely into the
fuse block location.
N29C0200
N29C0010
292
EMERGENCIES
CAUTION!
• Never use a fuse with a capacity larger than that
specified or any substitute, such as wire, foil, etc.
Doing so will cause the circuit wiring to heat up
and could cause a fire.
• If the newly inserted fuse blows again after a
short time, have the electrical system checked by
an authorized dealer to find and correct the cause.
REPLACEMENT OF LIGHT BULBS
Before replacing a bulb, be sure the light is off. Do not
touch the glass part of the new bulb with your bare
fingers; the skin oil left on the glass will evaporate when
the bulb gets hot and the vapor will condense on the
reflector and dim the surface.
Bulb capacity
A bulb should only be replaced with a new bulb of the
same rating and type. The designation can be found on
the base of the bulb.
Outside
Description
Wattage or
Candela
Power
ANSI Trade
No. or
Bulb type
1 - Front turn signal and
parking light
2.2cp
3157NAK
2 - Headlight
65/55W
9007(HB5)
3 - Front side marker light
1.5cp
194NA
4 - Front fog light (if so
equipped)
37.5W
896
N10B2820
EMERGENCIES
293
8
Description
Wattage or
Candela
Power
ANSI Trade
No. or
Bulb type
5 - High-mounted stop light
18w
921
6 - Stop and tail light
32/2cp
2057
7 - Rear turn signal and tail
light
32/2cp
2057
8 - Rear side marker light
5W
W5W
9 - License plate light
3cp
168
10 - Back up light
32cp
1156
Inside
Description
Wattage or
Candela Power
Dome Light
10W
Reading light
4W
Rear personal light
8W
Trunk light
5W
N10B2830
294
EMERGENCIES
Headlights
1. Loosen the bolt (A), move the horn (B) (left side only).
2. Push the connector (C) to disconnect and remove the
harness connector.
N10C1760
N10C1880
EMERGENCIES
295
8
3. Remove the locking cap (D) by turning it counter-
clockwise.
4. Remove the bulb (E).
N10C1890
N10C1900
296
EMERGENCIES
CAUTION!
• Never hold the halogen light bulb with a bare
hand, dirty glove, etc. The oil from your hand
could cause the bulb to break the next time the
headlights are operated.
If the glass surface is dirty, it should be cleaned
with alcohol and installed after drying thor-
oughly.
Adjustment of headlight aim
The alignment of the headlights should be checked by an
authorized dealer.
Front turn signal and parking lights
Turn the light socket (A) counterclockwise and pull it out
and remove the light bulb.
N10C1160
N10F0820
EMERGENCIES
297
8
Front fog lights (if so equipped)
1. Insert a screwdriver as shown in the illustration and
remove the screws.
2. Slide the light unit outward to remove it. Turn the
light socket counterclockwise and pull it out.
N10X1630
N10X1460
298
EMERGENCIES
3. Pull both clips (A) away from the center as shown and
remove the bulb from the socket by pulling out.
4. When mounting the light unit, align the pins (A) on
the light unit with the holes in the body.
N10X1700
N10X1740
EMERGENCIES
299
8
CAUTION!
• Never hold the halogen light bulb with a bare
hand, dirty glove, etc. The oil from your hand
could cause the bulb to break the next time the fog
lights are operated.
If the glass surface is dirty, it should be cleaned
with alcohol and installed after drying thor-
oughly.
Front side marker lights
Turn the light socket counterclockwise and pull it out and
remove the light bulb.
N10X1770
N10D0170
300
EMERGENCIES
Rear combination lights
1. Turn the trim cover clip (A) counterclockwise and
remove the trim cover clip. Partially remove the trim
cover in the trunk.
2. Remove the light case mounting nuts. Disconnect the
connector.
N20I0170
N20I0160
EMERGENCIES
301
8
3. Slide the light unit outward to remove it. Remove each
bulb socket assembly by turning it counterclockwise.
Remove the bulb from the socket by turning it counter-
clockwise while pressing it inward.
High-mounted stop light
Remove the socket assembly and bulb together by turn-
ing it counterclockwise.
Remove the bulb from the socket by pulling out.
N20I0290
A - Stop and tail light
B - Rear turn signal and tail
light
C - Rear side marker light
N10V0710
302
EMERGENCIES
License plate light
Remove the lens mounting screws, remove the socket
assembly and the bulb together by turning it counter-
clockwise. And remove the bulb by pulling out.
Back up lights
1. Remove the light mounting screw and pull the entire
light bracket out.
N10J0310
N11H0140
EMERGENCIES
303
8
2. Push the connector (A) to disconnect and remove the
light bulb.
3. Remove the entire socket and bulb assembly (B) by
turning it counterclockwise.
N11H0150
N11H0160
304
EMERGENCIES
4. When mounting the light unit, align the pin (C) on the
light unit with the hole in the body.
Trunk light
Pull both clips away from the center as shown and
remove the light unit. Then remove the bulb by pulling
out.
N11H0170
N10O0230
Clips
EMERGENCIES
305
8
Dome light
1. Insert a flat blade screwdriver into the notch of the
light assembly and pry gently downward to remove it.
NOTE
: Wrap a cloth around the tip of the screwdriver to
avoid scratching the light assembly.
2. Remove the light bulb from the light holder.
N10M0380
N10M0410
306
EMERGENCIES
Reading lights
Insert a straight blade screwdriver into the notch of the
light assembly and pry gently to remove the lens.
Remove the light bulb from the light holder.
NOTE
: Wrap a cloth around the tip of the straight blade
screwdriver in order to avoid scratching the lens.
Rear personal light
Insert the tip of a flat blade screwdriver at the edge of the
lens, pry gently to remove the lens, and then remove the
bulb from the light holder.
NOTE
: Wrap a cloth around the tip of the screwdriver in
order to avoid scratching the lens.
N11I0040
N10Q0090
EMERGENCIES
307
8
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст