Toyota Tundra (2019 year). Manual — part 26
401
5-10. Using the voice command system
5
Mu
ltim
The Mobile Assistant feature will activate Apple’s Siri
®
Eyes Free
mode via the steering wheel switches. To operate the Mobile Assis-
tant, a compatible cellular phone must be registered and connected to
this system via Bluetooth
®
. (
P. 363)
Press and hold the
until
you hear the beeps.
The Mobile Assistant can be
used only when the following
screen is displayed.
To cancel the Mobile Assistant,
select “Cancel”, or press and
hold the
on the steering
wheel.
To restart the Mobile Assistant
for additional commands, press
the
on the steering wheel.
• Mobile Assistant can only be restarted after the system responds
to a voice command.
• After some phone and music commands, the Mobile Assistant
feature will automatically end to complete the requested action.
■
Adjusting the Mobile Assistant volume
The volume of the Mobile Assistant can be adjusted using the
“PWR/VOL” knob of steering wheel volume switches. The Mobile
Assistant and phone call volumes are synchronized.
Mobile Assistant
1
2
402
5-10. Using the voice command system
■
Notes about Mobile Assistant
●
The available features and functions may vary based on the iOS version
installed on the connected device.
●
Some
Siri
®
features are limited in Eyes Free mode. If you attempt to use an
unavailable function,
Siri
®
will inform you that the function is not available.
●
If
Siri
®
is not enabled on the cellular phone connected via Bluetooth
®
, an
error message will be displayed on the screen.
●
While a phone call is active, the Mobile Assistant cannot be used.
●
If using the navigation feature of the cellular phone, ensure the active audio
source is Bluetooth
®
audio or iPod in order to hear turn by turn direction
prompts.
403
5-11. Bluetooth
5
Mu
ltim
Bluetooth
®
■
When using the Bluetooth
®
audio system
●
In the following conditions, the system may not function.
• If the portable audio player is turned off
• If the portable audio player is not connected
• If the portable audio player’s battery is low
●
There may be a delay if a cellular phone connection is made during
Bluetooth
®
audio play.
●
Depending on the type of portable audio player that is connected to the sys-
tem, operation may differ slightly and certain functions may not be available.
■
When using the hands-free system
●
The multimedia system is muted when making a call.
●
If both parties speak at the same time, it may be difficult to hear.
●
If the received call volume is overly loud, an echo may be heard.
If the Bluetooth
®
phone is too close to the system, quality of the sound may
deteriorate and connection status may deteriorate.
●
In the following circumstances, it may be difficult to hear the other party:
• When driving on unpaved roads
• When driving at high speeds
• If a window is open
• If the air conditioning is blowing directly on the microphone
• If there is interference from the network of the cellular phone
■
Conditions under which the system will not operate
●
If using a cellular phone that does not support Bluetooth
®
●
If the cellular phone is turned off
●
If you are outside of cellular phone service coverage
●
If the cellular phone is not connected
●
If the cellular phone’s battery is low
●
When outgoing calls are controlled, due to heavy traffic on telephone lines,
etc.
●
When the cellular phone itself cannot be used
●
When transferring contact data from the cellular phone
404
5-11. Bluetooth
■
Bluetooth
®
antenna
The antenna is built into the display.
If the portable audio player is behind the seat or in the glove box or console
box, or is touching or covered by metal objects, the connection status may
deteriorate.
If the cellular phone is behind the seat or in the console box, or touching or
covered by metal objects, the connection status may deteriorate.
■
Battery charge/signal status
●
This display may not correspond exactly with the portable audio player or
cellular phone itself.
●
This system does not have a charging function.
●
The portable audio player or cellular phone battery will be depleted quickly
when the device is connected to Bluetooth
®
.
■
When using the Bluetooth
®
audio and hands-free system at the same
time
The following problems may occur.
●
The Bluetooth
®
audio connection may be interrupted.
●
Noise may be heard during Bluetooth
®
audio playback.
■
About the contact in this system
The following data is stored for every registered cellular phone. When
another phone is connecting, you cannot read the registered data.
●
Contact data
●
Call history
●
Favorite
●
Message
When removing a Bluetooth
®
phone from the system, the above-mentioned
data is also deleted.
405
5-11. Bluetooth
5
Mu
ltim
■
Compatible models
The Bluetooth
®
audio system supports portable audio players with the follow-
ing specifications
●
Bluetooth
®
specifications:
Ver. 2.0, or higher (Recommended: Ver. 3.0+EDR or higher)
●
Profiles:
• A2DP (Advanced Audio Distribution Profile) Ver. 1.0, or higher
(Recommended: Ver. 1.2 or higher)
This is a profile to transmit stereo audio or high quality sound to the multi-
media system.
• AVRCP (Audio/Video Remote Control Profile) Ver. 1.0 or higher
(Recommended: Ver. 1.4 or higher)
This is a profile to allow remote control the A/V equipment.
However, please note that some functions may be limited depending on the
type of portable audio player connected.
The hands-free system supports cellular phones with the following specifica-
tions.
●
Bluetooth
®
specification:
Ver. 2.0 or higher (Recommended: Ver. 3.0+EDR or higher)
●
Profiles:
• HFP (Hands Free Profile) Ver. 1.0 or higher (Recommended: Ver. 1.6 or
higher)
This is a profile to allow hands-free phone calls using a cellular phone or
head set. It has outgoing and incoming call functions.
• OPP (Object Push Profile) Ver. 1.1 or higher (Recommended: Ver. 1.2)
This is a profile to transfer contact data. When a Bluetooth
®
compatible
cellular phone has both PBAP and OPP, OPP cannot be used.
• PBAP (Phone Book Access Profile) Ver. 1.0 or higher (Recommended:
Ver. 1.1)
This is a profile to transfer contact data.
If the cellular phone does not support HFP, you cannot register it with the
hands-free system. OPP, PBAP services must be selected individually.
406
5-11. Bluetooth
■
Reconnecting the portable audio player
If the portable audio player is disconnected due to poor reception when the
engine switch is in the “ACC” or “ON” position, the system automatically
reconnects the portable audio player.
If you have switched off the portable audio player yourself, follow the instruc-
tions below to reconnect:
●
Select the portable audio player again
●
Enter the portable audio player
■
When you sell your car
Be sure to delete your personal data. (
WARNING
■
While driving
Do not use the portable audio player, cellular phone or connect a device to
the Bluetooth
®
system.
■
Caution regarding interference with electronic devices
●
Your audio unit is fitted with Bluetooth
®
antennas. People with implantable
cardiac pacemakers, cardiac resynchronization therapy-pacemakers or
implantable cardioverter defibrillators should maintain a reasonable dis-
tance between themselves and the Bluetooth
®
antennas. The radio waves
may affect the operation of such devices.
●
Before using Bluetooth
®
devices, users of any electrical medical device
other than implantable cardiac pacemakers, cardiac resynchronization
therapy-pacemakers or implantable cardioverter defibrillators should con-
sult the manufacturer of the device for information about its operation
under the influence of radio waves. Radio waves could have unexpected
effects on the operation of such medical devices.
407
5-11. Bluetooth
5
Mu
ltim
NOTICE
■
When leaving the vehicle
Do not leave your portable audio player or cellular phone in the vehicle. The
inside of the vehicle may become hot, causing damage to the portable
audio player or cellular phone.
408
5-12. Antenna
Antenna
Place the included wrench
around the antenna.
When not in use, the wrench is
stored in glove box.
Loosen the antenna with the
wrench and remove it.
Tighten the antenna by one
hand until it will not turn any
more.
Using the wrench, tighten the
antenna an additional 1/8th turn
(20 to 45 degrees) to secure it
in place.
After tightening the antenna,
remove the wrench.
Removing the antenna
1
2
Installing the antenna
1
2
409
5-12. Antenna
5
Mu
ltim
■
About the wrench
After using the included wrench, store it in the glove box for safekeeping.
NOTICE
■
To avoid damaging the antenna
Remove the antenna in the following situations.
●
When using an automatic carwash.
●
When the antenna will touch the ceiling of a garage, etc.
●
When covering the vehicle with a car cover.
■
Removing the antenna
●
For normal driving, make sure the antenna is installed.
●
When removing the antenna to use an automatic carwash, etc., be careful
not to lose the antenna. Also, make sure to reinstall the antenna before
driving the vehicle.
■
Using the wrench
●
When installing or removing the antenna, use the included wrench.
●
Be careful not to scratch or damage the vehicle body with the wrench.
●
Do not over-tighten the antenna.
Over-tightening may damage the antenna.
●
Do not use any tools other than the included wrench to install or remove
the antenna.
Otherwise damage may result on the antenna’s finish.
410
5-12. Antenna
411
6
Interior features
6-1. Using the air conditioning
system
Manual air conditioning
system. . . . . . . . 412
Automatic air conditioning
system. . . . . . . . 419
Seat heaters/
seat ventilators. . . . 426
6-2. Using the interior lights
Interior lights list . . . . 429
• Personal/interior lights
main switch . . . . ... 430
• Personal/interior
lights . . . . . . . . 430
• Cargo lamp main
switch. . . . . . . 431
6-3. Using the storage features
List of storage features . . 432
• Glove box. . . . . .. 434
• Console box (front
separated type seat) . . 435
• Card holder . . . . ... 436
• Map holder (front
bench type seat) . . ... 438
• Pen holder . . . . . 439
• Tissue pocket. . . . 440
• Overhead console. . . 441
• Cup holders . . . . .. 442
• Bottle holders. . . . 444
• Auxiliary boxes (front
bench type seat) . . ... 445
• Storage box . . . . .. 447
Luggage compartment
features. . . . . . ... 449
6-4. Using the other interior features
Other interior features . ... 450
• Sun visors . . . . . . 450
• Vanity mirrors. . . . 450
• Clock. . . . . . . . 451
• Power outlets . . . . 452
• Armrest . . . . . . . 454
• Assist grips . . . . ... 455
412
6-1. Using the air conditioning system
Manual air conditioning system
■
Adjusting the temperature setting
To adjust the temperature set-
ting, turn the temperature con-
trol dial clockwise (warm) or
counterclockwise (cool).
If
is not pressed, the
system will blow ambient tem-
perature air or heated air.
For quick cooling, turn the tem-
perature control dial to the “MAX
A/C” position.
The air conditioning will automatically turn on and the air intake selector
will be set to recirculated air mode.
: If equipped
Air conditioning controls
413
6-1. Using the air conditioning system
6
Interio
■
Fan speed setting
To adjust the fan speed, turn
the fan speed control dial clock-
wise (increase) or counterclock-
wise (decrease).
Turning the dial to “OFF” turns
off the fan.
■
Change the airflow mode
To select the airflow, set the air
outlet selector dial to the
desired position.
The positions between the air
outlet selections can also be
selected for more delicate
adjustment.
■
Other functions
● Switching between outside air and recirculated air modes
(
● Defogging the windshield (P. 414)
● Defogging the back window (CrewMax models) (P. 414)
● Defogging the outside rear view mirrors (if equipped) (P. 414)
● Windshield wiper de-icer (if equipped) (P. 415)
414
6-1. Using the air conditioning system
■
Switching between outside air and recirculated air modes
Press
.
The mode switches between outside air mode (introduces air from
outside the vehicle) (indicator off) and recirculated air mode (recy-
cles air inside the vehicle) (indicator on) each time the button is
pressed.
■
Defogging the windshield
Defoggers are used to defog the windshield and front side win-
dows.
Set the air outlet selector dial to
position.
Set the outside/recirculated air mode button to outside air mode if the recir-
culated air mode is used. (It may switch automatically.)
To defog the windshield and the side windows early, turn the air flow and
temperature up.
■
Defogging the back window (CrewMax models)
Defogger is used to defog the back window.
Press
.
The defogger will automatically turn off after approximately 15 minutes.
■
Defogging the outside rear view mirrors (if equipped)
Defogger is used to defog to remove raindrops, dew and frost from
the outside rear view mirrors.
Press
or
.
The defogger will automatically turn off after approximately 15 minutes.
CrewMax models: Turning the back window defogger on will turn the out-
side rear view mirror defoggers on.
Other functions
415
6-1. Using the air conditioning system
6
Interio
■
Windshield wiper de-icer (if equipped)
This feature is used to prevent ice from building up on the wind-
shield and wiper blades.
Press
or
.
The defogger will automatically turn off after approximately 15 minutes.
Double Cab models: Turning the outside rear view mirror defoggers on will
turn the windshield wiper de-icer on.
CrewMax models: Turning the back window defogger on will turn the wind-
shield wiper de-icer on.
■
Location of air outlets
Air outlets and air volume
changes according to the
selected airflow mode.
*
: CrewMax models
■
Adjusting the position and opening and closing the air outlets
Front
Direct air flow to the left or right,
up or down.
Air outlets
*
416
6-1. Using the air conditioning system
Open the vent
Close the vent
Rear (CrewMax models)
Direct air flow to the left or right,
up or down.
Turn the knob to open or close
the vent.
1
2
1
2
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст